Search results

it is a used inpeller but its not bent or dingled, turns in the pump really smooth by hand.

Finally got my ski together and in the water this weekend. I had a vibration felt through the entire ski. When coming back down to idle it actually would feel worse. I was thinking the engine isnt aligned properly, but before ripping everything apart i thoguht i would post and see if...

http://x-h2o.com/showthread.php?t=18106

Im painting my ski pearl white and have some blue grpahics going on it. I was thinking of adding a little gold to the clearcoat. Ive seen this over black paint and it looked awesome. My question is, will it give me that effect on the white paint and blue grpahics. Are there standard...

wirewheel it and use it

starter is bad, engine is seized, or something is broken inside and is preventing the motor from turning over, or somethign is stuck in the pump. Try turning it by hand with the plugs removed. If it turns you probably have a bad starter

Thanks Matt. I was hoping to hear someone removed them and didnt have a problem.

Thanks Kaveman on the x2 i had to put them about 40" from the rear of the ski. Alot differnt then any other on teh instructions. I put mine on with Epoxy resin and some biax cloth. Do you guys remove the screws once your resin/5200 cures? Some are sticking up and need to be grinded down.

the installation itself is the same but the front back and height from the bottom of the hull is different. IF i went with the 750SX or SXI or teh SJ instructions it put it at a part of the hull that is too narrow for the tubbie and the bottom of the tubbie hangs off the bottom of the hull...

I did not make them myself, i was just stating that if someone took the time and effort and made them themselves rather then blowing a wad of cash you guys wouldnt help them out? I certainly would. Blowsion came through though. The X2 installaion is not like any other ski so they really...

are you guys serious??? if someone made a pair themselves you wouldnt help them out with moutning instructions? Gotta be kidding me. Thanks to the guys who offered help. I just called blowsion and they are emailing them over. Kaveman, if they dont fit per the instruction i will be...

I do have some gaps. What do you guys think of using a hot glue gun. That stuff sets up in a minute or 2 and i think it should be easier to get off then silicone.

I misplaced mine. Anyone have an electronic copy? Or have the meausrements they give you for front to back placement and up down placement specs. If the measurement are model specific, this is going on an X2.... they probably donthave x2 instrucs so maybe the 650 or 750 SX would be the...

Getting the boat finsihed up and i know i will be doing alot of impeller swapping till i find the right combo. I have several props on hand so they would be changed same day. Do you guys have a way to temporarily seal the pump that would last a day or so to test ride with the different...

i tried ordering one for a 1990 today and they said they are not made anymore. Ill try tomorrow for a later model and see if i can get one

Anyone know where to get one? Or have you found an effective alternative?

48mm. Have you tried calling Ed? He should be able to get you pretty close. www.fastcarbs.com

157.5 HS 127.5 LS 2.3NS 115g spring HS screw is 7/8 out, LS Screw 1 1/8th out. I have my return drilled out and have a 70main jet as a restictor flowing back to the gas tank

i went with the single Full Spec on my Kawi 750 which has been built by Team scream and taken out to 780. I have not run it yet but will let you know. I was told WOT runs are not a problem.

can you post a pic of the head. I have a mariner head on a 650 and its one piece.