Search results

doug lee and me are thinkin bout hitting up barngate light this weekend

I think all yamaha's have that mismatch. I think the pealed paint scarded him away because it's a sign of overheating. I cracked open a 650 that was untouched since 90 when it was born, I thought it was dead because of age so I pulled it appart. I was amazed with the motor. It still had the...

My $22 wal-mart comp gauge has the valve at the end of the hose by the head. I Doubt the reading it gives is accurate relative to what my actual compression is. It is precise enough to tell me if something is up with the motor and that’s all I really have it for.

My single kawi manifold on my 62t cases gets almost ice cold when the motor is running. Especialy when its run at part throttle. The cases will be up to temp but the manifold is very cold.

Is there any diff running t cases with a single vs. x with a single??

What Properties does texalium have over fiberglass?? Besides looks. I know they use it snow skis and it looks awesome, especialy with colored resin.

I'm guessing alot of low end gain comes from that pipe. Kind of like the long head pipes on trials bikes. Some one should take advantage of the extra room the XFT fuel tank allows and make a chamber for the b-pipe or see if the sxr bpipe fits and if it offers any gains. The whole ski just looks...

The flywheel bolts look like polaris and so do cases/reed bolts. The motor mounts look diff though. That pipe is awesome looks like the octane dry or type 8 manifold. I can't get over the chamber. Adet16v was telln me that his ski he rode at the pittsburgh regatta had a 3/4 inch pisser :shock:

He never sent me the bendix back. I have had that happen though. People think ebay is walmart and you can just buy a new one and return the old one in the same box and its not going to matter.

single carb 650 and 701 yamaha brackets work perfect

Going Propless

Jett, Have you ridden the ski with the cut plate yet?

I have the rec tubbies on my square with a Wammer plate. The long plate takes alot away from the tubbies you really need to get your weight back to keep the back hooked up as the front end is alot grippier. The ski begs layed down hard in turns. It does not like to do turn subs at all. The chine...

us composites epoxy and west systems 410

Those studs take all of the loading that the cylinders normaly take and then some. I would bet that it isn't off the shelf hardware that ADA just orders and bulk and throws in a bag.

He has pulled every line and fitting on this ski as well as the head checking for sand in the jugs. Can Messed up plugs or Msd cause this? Or a messed up stator vien? I really have no clue what it could be after checking for obstructions. If there is plenty of water going through it how is it...

The ADA heads use long studs and so do the AJS heads which are ADA's but say Atlantic jetsports and are cheaper. http://www.atlanticjetsports.com/cylinder_heads_-_ada_racing.htm YA701G6 is the stud kit call them an make sure it has the acorn nuts and washers because it says 6pc Here's...

I did an fx1 pole on a square with a round nose braket and its a little high in the front but it doesn't look out of place. With A lowered braket you should be perfect. If anything the hood will need to be chopped down to look right because the top of the round nose pole sits lower then top of...

doug, You can launch on 10th in north wildwood but its a half hour ride out through the inlet and 20min of that is no wake. You used to be able to beach along the inlet not sure any more because there has been alot of construction. You might be better off toting it onto the beach. There are...

QJS, Does the spacer move the carb out like a reed spacer???