Search results

u I am sure someone will sell you theirs. :scratchchin: Mark44

Very nice welcome. Mark44

Seems a little tight. IMO I run .045 Mark44

I still say push a piece of round EDPM in the center of the seal to fill the D void. Mark44

McMaster Carr has those quick disconnect ends. Mark44

No clue?????????????? Mark44

Cut it big then trim to fit also use lots of heat and beat the heck out of it with a rubber mallet after it’s down. Mark44

Cool I will keep an eye on there deals. Mark44

I have also done this but like the valve much better its worth the price. Mark44

You can get it from jetworks and you need the 3/8" http://www.jetworks.net/ Mark44

I I will have to take a pic of it. It is a piece of tubing about 3” long that I had our machine shop make a hole saw out of, they formed teeth on one end and put a tee handle on the other. I place it on the cut off plug wire then turn and push till It hits the bottom of the hole when I pull...

I made a tool to get the old wire out it takes about 3 minutes. I have also searched for 20 strands 0 resistance wire and found it locally at a speed shop. Mark44

I rode XFT-Lou’s ski and I like the holds they really keep your feet in place the only thing I don’t like about them is that they use up the entire tray in the rear. Mark44

y Yea when the ski lands on the hood from 10'.LOL Other than that they will hold fine if not you needed new mounts. Mark44

Not a problem I would just have the fuel tank empty. Mark44

#2 is the part in question. Mark44

Looks like a nice seal but would be a lot better with out the hollow D-shape. Some one may want to try and purchase a piece of round EPDM from McMaster and run it up through the center to firm it up such as part number 6289K14 IMO Mark44

t This feels like winter time on X-H2EGO...............:chairshot: Mark44

Grind it out a little then tig it up.

i Or jump over the rail and swim in the pool with the blue tarp.:crying: Is Yah-Ki going? Damn I miss partying with him.:headbang: Mark44