Search results

I just had prop spacers machined and finally putting the pump back together. I have some serious gaps between the nozzle and pump. I received a rubber spacer that does not take up all the slop between the pump and nozzle. Its not even close. It seems that no matter how i line up the pump and...

Ok, i am going to buy an impros hooker prop, read lots of good things on here about it. Can't wait to try it out!!

I ran into some spacing issues with the prop and the solas mag pump. I have a solas concord prop that does not fit up to the solas pump. When I went to tighten down the prop, it pinched between the prop and pump. The hub diameter is larger on the solas pump versus the oem pump, also the pump hub...

I just bought one and will have it installed in the next week or two, I have heard the gain is decent, less rotating mass equals more brap. Installation is not to bad, you need a wheel puller to get the flywheel off, then the next trick is to torque it back down while keeping the crank from...

got it. thanks.

I am replacing the pump stator on my 2001 sj with the solas mag setup. I have it pulled apart, just need a little guidance on pulling the shaft out. Can I leave the prop on the shaft when I press the shaft out pressing from the exit direction? The manual seems to show pushing the shaft out from...

thanks for the info!

When your ski breaks down in the water and you have to be towed in, does that flood your engine with water? A friend of mine put shut off valves in his waterlines incase he breaks down. wondering if that is necessary? does it matter if you tow the ski backwards or forwards? Thanks.

yes, get some three bond 1211 or yamabond4. clean the old off and put the new on.

Figured out that less is more when it comes to the weldwood contact cement, going a lot better now! All I have to do now is the front bumper. Anyone have advice on how to cut the front bumper out. Not sure if I should follow the contour or just cut a straight piece out like this picture in...

thanks for the tips. I am using the right glue, maybe i just need to let the glue dry a little more before I apply it. Anyone have suggestions on how to cut the front bumper shape out of the mating? the 2 pics above show what I was thinking, not sure which way to go with it.

I am using the contact cement you get at Menards. I have been applying the cement to both surfaces and letting it tack up. Also using a heat gun. Anyone have tips on doing the front bumper? I am uncertain how to cut the turf. With the rounded edge/shape of the bumper there is going to be...

Well, just had the fx1 painted and have the tray all turfed. Ran into problems turfing the rails and front bumper area. What kind of adhesive do you guys use to turf the rails? the contact cement that I am using takes forever to cure and i am finding it hard to keep the turf clamped in the right...