The "Snack Machine"
- Thread starter Snackem
- Start date
No turf, perhaps tomorrow. 650 for the ocean, but with the light flywheel
perhaps.
It might be ok with a stock cone and nozzle, but its fairly low for a 750 and might cavitate. Only one way to be sure.
Hogggman
Stock Sucks
- Location
- White Lake MI
Id think twice about putting them into thetrayI have mine that way on my blaster last year a fuel line popped off when I turned the pumps on it filled the trays with oily water it is still slippery to this day. Luckily I have black turf so it didnt stain but every time it gets wet i almost slip off.
Well we did some work to the X2 yesterday and a lot more on Matt's RN (we got to put in the right foothold twice because of impatience and poor planning:banghead
. I ran into some problems with the electronics on the 750. Things wouldn't "fit" and still seal inside of the 750 e-box. So now I'm going to take everything out of the 650 box and put the 750 electronics into the 650 box. It's a PITA. I hate electrical stuff. . .
. I ran into some problems with the electronics on the 750. Things wouldn't "fit" and still seal inside of the 750 e-box. So now I'm going to take everything out of the 650 box and put the 750 electronics into the 650 box. It's a PITA. I hate electrical stuff. . .Thats what zip ties are for, it should never happen.
Well we did some work to the X2 yesterday and a lot more on Matt's RN (we got to put in the right foothold twice because of impatience and poor planning:banghead
I hope you get that sorted out soon, not sure why the wires won't fit in there, but be carefull closing it up. My neighbor was in a hurry on his TS and pinched a wire. When he started it up it ran for 5 seconds then the wires caught fire and fried everything to the stator.
What you will find is there are not too many good places to put them where they won't interfere with something. With my scupper in, the pump is only in there so it won't sink when sitting or if the scupper leaks.
Hogggman
Stock Sucks
- Location
- White Lake MI
It was zip tied sometimes stuff happens that isnt supposed to
The wires will "fit" into the 750 box but on of the holes to put the wires in through has a different kind of fitting. Instead of the ones that screw into the side of the box this has four wires (the four heading to the start/stop switch) that pass through a gasket that kind of snaps into the side of the box so when I just swap the wires out then the box does not seal tight. I am going over to look at it again today after we turf Matt's RN.
Phill
v Check out Little Matt_E
- Location
- Kennewick, WA
:haha: :bigeyes:.....on Matt's RN (we got to put in the right foothold twice because of impatience and poor planning:banghead
Tell us more....please:sneaky:
I thought he had 2 left feet...lol.
WFO Speedracer
A lifetime ban is like a lifetime warranty !
- Location
- Alabama
Throw up a pic of that Snakem,I believe I ran into the same thing when I put the 750 engine into the super chicken.
It had something to do with 'exploding footholds'.
16 ounces of warm unexpanded foam
Poorly mixed epoxy resin
+ 'nearly' cured glass
a foam volcano the pushes the bottom of the foothold up and oozes foam down the side of the nice paint job.:banghead: :banghead:
It was kinda cool to watch :bigeyes:
What exactly do you want to see pics of?