Search results

Shoes arrived quickly and were exactly as advertised , shoes look like brand new and they fit ,me perfectly , thanks Steve , you crack me up , this is how Steve addressed my package lol. My Business Paypal is Lake Martin Best so I guess I am now I have a new alias , Martin Best lol

Most likely a bad fuel needle but unless you have a way to check popoff you will never know for sure. How does the throttle shaft play look on the carb?

I agree on the compressed trim seal , I have had to back them up with sealant before to get them to seal.

I also have a running Brut engine in the ski I could do some electrical tests on. I don't know about a PDF but I can take a pic of the pages and send it for sure, going up there tomorrow I will take a looksee.

I don't think anything would stick to that type of plastic

I am starting to wonder if it would be worth it to make some molds of some of these Yamaha seats, I know the Waveventure -Waverunner XL seats are bad about the base disintegrating as well and good luck finding good ones , there are some new epoxy resins out now that you can make flexible parts...

I have a brand new Tigershark pump amd several Tigershark 640 engines laying around that I could use for this project.

A few more pics of the hidden tongue jack, gas can caddy and the storage compartment , I would have to do something else with that spare tire , plenty of room in front of the gas can caddy to bolt it down.

Porting , a two stroke motor can be ported to have great bottom end and no top end like on a Trials motorcycle, or great top end with no bottom end like on a motocross bike or anything between the two extremes.

They want their toys back , these are two of the cleanest 650SX skis I have ever worked on and the trailer is gorgeous but needs some help in the functionality department. It just has a flat carpeted pad which means nothing keeps the skis stable side to side and it's being held on by ratchet...

I often wondered if you could just cut a hole the right size and bolt an ARTIC CAT pump ino one of these.

Somewhere I have a factory Brut shop manual , give me a few days and I will see if I can dig it up for you.

That cheddar is looking really sharp ! One trick I learned was to take one oven rack out , then you can flip the cylinder upside down and support it on two bricks at the ends , a lot of times the cylinders will just drop out that way when they reach the correct temperature , but you are...

Oh yeah I am sure of it , I thought I got it all when I cleaned the gun, but apparently I didn't.

This thing is cursed, it looked great when I left for the lake at lunch, but this morning it have some like speckles in it, so I wet sanded it with 1000 grit and found a few chunks of prime embedded into the pain, upon trying to sand them out it went through the paint in two places so time for...

Remove the oil tank with the lines and the oil pump all still attached , install block off plate ,then do what Mike W said.

Nothing to come out , I sanded IT down to the shell and primed it with high build 2k Urethane primer. When this primer kicks, it kicks hard , I know this because it tried to kick in my gun a few days ago.

At any rate Abra - Abracadabra. I'm gonna reach in my bag bruh Abra - abracadabraabra. , and just like that I'm back bruh ! I got three coats of Kirker ultra-glo single stage on it this morning,, the first two were not that impressive so reached into my bag of tricks , I sprayed the last coat...

I am thinking you will be ok then, you might have to tweak the screws in till it runs right, just go in an 1/8 a turn at a time till it runs correctly , start with the low speed then when you have that dialed in set the high speed screw , You might also want to look at the 650 pipe mod , it...