Search results

Gap the spark plugs real tight like the space of 2 fingernails

You can cut the extensions down if you want to. Also you will get used to the wide bars after a ride or 2

Hey not trying to be a pain in the ass but I know you said you are positive it's not the carbs because you went through them and they are clean but that doesn't mean something isn't wrong with them. My buddy had a set of 38s that he rebuilt with all brand new mikuni parts and the carbs were...

He removed the footholds and just has a front foot hold and the strap has one bolt on the tray and the other on the side so it's just like a regular foot hold. Surf stance flips and rolls are no prob and the strap holds better then the ninjas

Anyone else's vinyls peeling off the bottom

I did the same thing about a month ago my pinky toe still hurts. I love the way they hold your foot but man did that hurt. Also my buddy put a strap instead of the hold and I gotta say it's way better.

Did you break the engine in with those domes. I've seen brand new rebuild with 210-220 psi drop down to 190ish after the break in. Also if you replaced the base gasket that can change numbers as well.

Haha we were doing the same but I can't remember where it was posted

Do you have dual cooling from the pump?

If you have single cooling from the pump then it's the rear head line goes to the bottom of the pipe. Stinger line stays the same

You want both head pisseres to go over board and the line from the top of the pipe should have a tee to the stinger and that tee goes over board.

I would never waste my money on a completely stock Superjet. For $8k I would buy a modded SJ and take the extra money to make it perfect.

I used to use surf booties when it was cold out they were great but they were to small in my footholds.

When you say freeride do you mean surf. Cause if so you will snap that pole if you ride hard enough.

That MSD is shot. I had the exact same problem I bought a "good used MSD" put it in but I didn't take off my battery and most likely fired the MSD on my own. But exact same problems you are having, I thought it was the white wires as well we ended up putting the MSD in a running ski with MSD and...

Check midshaft seal. You might be pulling air into your pump.

I wish I had the money for the plane ticket and hotel I would love to go to this event.

yes it happened to me on sunday with 1 ride old plugs I had spark but the ski wouldn't start and we didnt have another set of plugs on hand so we took one plug and put it in a running ski heated up the plugs then did the other and then they both worked

Clogged return line. Is my guess if you ran out of fuel you may have sucked some stuff up and clogged something in the carb. As speedysproket said check spark and new plugs first

Bump