Search results

does the xl have the bigger exhaust??? Also the electronics require some cutting to eliminate the wires that go to the gauge pod unless you want to hook up that up too.

I'm speachless

18' isn't that deep but with zero visability I bet its scary. I say hook something to it as a marker and use that as a guide to swim down over and over till you can get something through the bow/stern eye. When you get it tied off pull it very slowly to break the suction. Screw getting a diver...

The Fx1 pole is shorter and I think the steering stop is wider so you get a little less throw. Its plenty short on the square.

good, modding the stocker is a waste

Matt_E, What are you using for a steering cable???

I destroyed my oem coil trying to replace the wires

Who lightened your stock flywheel???

Just found oem coils on parker for $50. I was getting an open reading across my wires. I tried getting out the rubber but ended up cracking the casing. They were epoxied in almost all the way down. It tested well when I stuck some other wire down till it hit the spike. When They say you will...

Has anyone used their stock replacement coils for the 701&650 yamaha's/750 kawis??? I need a new coil and the msd's are $85 vs. oem which is more. Msd's site says it has improved spark blah blah blah, but if its gonna take a ******** on me I don't want anything to do with it. Thanx Ryan

Atlantic jetsports has a wiseco kit for about the price of the pro-x. They also have a cheap wsm kit as well as top end gasket kits for a pretty good price. Ebay pistons and a $45 topend gasket kit sounds like the way to go. Parker has slow shipping from what I've seen.

I could have used a multimeter this weekend. Makes finding a bad ground easy. Also helps sort out other electrical probs. It might not get you back on the water but atleast it will tell you when to give up. As for the b-pipe coulplers. I have used the 4" ones from home depot for pvc. They go...

how do you keep the ski from hitting the boat when you slow down?? Just sit backwards and put your feet on the nose?

How do you tow a superjet with no one on it and not sink it? Tried towing mine in behind a boat this weekend and it just went down so I had to ride on it while getting towed. thanx

THe pole has that stop to save the cables from getting sheared. I was going pull my stop for more hight but the only time I have the pole that high is when I am wrenching or wrecking.

Is the foam soaked on the right side???

I Doubt that will be happening anytime soon :banghead:

13mm box wrench to pull a carb 12mm boxwrench for the back motor mounts 10mm box wrench to tighten down the throttle cable magnet on a stick incase you drop a nut 1/4" drive sockets with extensions to get to the bottom of the intake manifold thats all stuff I have needed and not had in my...

thanxs demo thats what I needed to see

Can some one that goes there often give us lat & long from google earth. I know its at the tippy top but I don't want to start backing down a private slip.