WDK bracket what bolt?

[G-Body]

What pole bolt do I need to run with a water dawg kustoms pole bracket? I had a square nose bolt but it was way too long and I had a 3 inch stack of washers on it. I picked up a round nose bolt but it is flush with the end of the bracket, I can`t even get a jam nut on. I need a stainless bolt as I`m running a spring. Do I have any option besides cutting down and rethreading a SN bolt?

 

[High Speed Industries]

You could get a stock rn bolt or a RRP bolt.

 

[G-Body]

I tried a RN bolt and it was too short. The end was flush with the bracket. I put it in with locktite but by the end of the first ride it was backed most of the way out. Isn`t the RRP bolt aluminum so a spring will eat through it?

 

[Fro Diesel]

It was cheap to have a local motorcycle shop cut mine down and rethread. I did this to a few a bolts bc a rn bolt is twice the cost of cutting one an bolt downto fit
@Scraggly

 

[JetManiac]

What pole bolt do I need to run with a water dawg kustoms pole bracket? I had a square nose bolt but it was way too long and I had a 3 inch stack of washers on it. I picked up a round nose bolt but it is flush with the end of the bracket, I can`t even get a jam nut on. I need a stainless bolt as I`m running a spring. Do I have any option besides cutting down and rethreading a SN bolt?

What length is the bolt you have? WDK bracket uses a std length RN bolt. Cold Fusion also makes a SS RN pole bolt which we stock.

 

[MADMAT]

Yea my WDK used stock RN..

 

[G-Body]

I forgot to measure it before tucking the ski away for winter, but I thought it was a stock RN bolt. I did pick it up of ebay, but the listing didn`t mention anything about it being cut and it was a x-h2o member who sold it. What should the length on a stock RN bolt be?

 

[Parsonsjb88]

I'm not sure of the length of the RN bolt but I also have the WDK pole bracket and the stock RN pole bolt fits it perfectly. If I have a chance I'll measure mine tonight.

 

[G-Body]

I measured my bracket/bolt and it looks like someone must have cut the bolt down as they are both 7 3/4 inches. I believe the stock RN bolt is supposed to be 220mm? and that extra 24mm would give me plenty to get a jam nut on. Jetmaniac I will probably hit you up for a stainless cold fusion after daytona.