- Location
- Holland Michigan

Yes it's a carbon hull, Bilge is wired into the eboxis this a carbon rip?
if so how is your bilge switch wired?
My start stop switch had a short in the stop line that would make my ski cut out? Would this be the issue?Water in your flywheel cover. If the start stop switch was some how shorted it would shock you even if the boat wasn't running. Does the shock get stronger as rpm increases?
Shock does not increase with rpmsWater in your flywheel cover. If the start stop switch was some how shorted it would shock you even if the boat wasn't running. Does the shock get stronger as rpm increases?
ThisI would lean more towards a bad ground.
Hahaha I can handle the current going through my fingers but it's making my ski run like crap!quit being a sissy its only 12 volts
I do have a bilge pump but it's not hooked up, I noticed that all of the wires from the bilge are still attached except for the ground, could this be my problem?This happens a lot with worn out or cracked bilge pumps
I would lean more towards a bad ground.