Super Jet De winterized ski wont run right! Need help!

[Matt_E]

when i take the needles out were is the screw spot to take the jets out

^^Read the manual.

The jets have nothing to do with the needles.
You need to take the diaphragm cover off, then the diaphragm, then the jet block. Pilot & Main jet are under there.

READ THE MANUAL.

Edit: LOL. Not being a dick, but that manual really does cover all of your questions. Also how to tune the hi & lo adjusters.

 

[lcgordon]

Ya thanks for sending me that cuz im at school and my manual is at home. Ill try it when i get time ( studying now). And thanks again for the help

 

[lcgordon]

i took the jets out they looked really clean so i think maybe a rebuild kit is wwhat i need i cant think of anything else what do u guys think?

 

[Fro Diesel]

You definitely just need to get a bpipe and it will just be great. Yeah...great.

sent from Fro Diesel using tapatalk.

 

[Matt_E]

i took the jets out they looked really clean so i think maybe a rebuild kit is wwhat i need i cant think of anything else what do u guys think?

Needle & seat. Did I mention that yet?

 

[Idok]

Do yourself a big favor and read this. Then read it again.

http://mikuni.com/pdf/sbn_manual.pdf

Also this:
http://mikuni.com/pdf/sbn_rebuild-kit.pdf

mine sits on the crapper....I read it 2-3x a year, just to refresh

 

[lcgordon]

what do u check with the needle and seat i think it looked good? one of the seals looks bad i think and the diaphragm will not fit back in the slot anymore and its all warped.

 

[BruceSki]

Needle & seat. Did I mention that yet?

Quit mentioning stuff. You run jetworks stuff. Bet youve never seen the inside of a carb!!! Nanananana

 

[lcgordon]

any positive help? How can i tell if i need to rebuild the carb?

 

[Matt_E]

any positive help? How can i tell if i need to rebuild the carb?

If you can't Remember when it was done last, it needs to be done. It's not running right, so it would be a good idea to rebuild carbs.
Buy genuine mikuni rebuild kits (no aftermarket crap!) and new needle & seat.

What to look for in needle & seat: if you can see a groove in the needle tip, however small, replace it. Check the o-rings on the seat

 

[Matt_E]

Quit mentioning stuff. You run jetworks stuff. Bet youve never seen the inside of a carb!!! Nanananana

Yah but I fix plenty of old sitdowns in the summer

 

[lcgordon]

ok thanks only had the ski a year so i have never done it the needle and seat does not look like it has a grove in it at all it looks smoth and good

 

[BruceSki]

Yah but I fix plenty of old sitdowns in the summer

I know. I was just busting your chops. It seems like you gave advice in this thread multiple times and it fell on deaf ears.

 

[lcgordon]

thanks guys for the help i got it working