Search results

but with a WDK bracket???

i'm not even talking about the nose piece... with out the nose on, you still can't get the bolt out with out loosening or completely removing the pole bracket. But cutting one side of the bolt would probably work. Every bracket is not the same so it may work with some and not others though. I...

looks nice... i'd like to modify that area so that the pole bolt can be removed without taking the bracket off when using a lowered pole bracket. don't know if that is your objective or not.

yup, pole and pad are yours.

it won't be budget, but i'll have a 701 later this week.

ceramic coating... looks great. there have been a couple threads about this same or similar topic recently.

your welcome once again guys.

i have a complete ebox with a Stock CDI with an adjustable REV limiter if your interested

I sold Ben Swanson a 6 bolt Square nose Pro Tec ride plate. He received it and claimed it was bent and cracked upon arrival. He requested that I refund him half the money back if after his attempt to repair the ride plate was unsuccessful. I don't know about you all, but I have never seen a...

i have a set of 4 degree bars if you need them... but 0 are still better byotch

stock fuel lines are the best.

ummm no nothing yet... i've kinda gave up hope.

ah. glad to see your back. and who could ever forget that avatar???

i would run one. just makes me feel a little better about when my boat sinks

i have a sheet of grey B stock in my garage rafters... only have a strip 1.5" wide taken off one end... could be worth some money... hehehe, j/k

i think you can check them through either KBB or NADA. I have done it once before.

ding ding ding... You are correct.

i rode carls fx-1 with a 144 pump and i could stay on that damn thing. it was in some nasty chop, but i could not stop falling over. F' the FX I'll stick with my Roundie I started with 650sx, then 550, then SXR, and since then 2 Roundies and a square.

well it looks right. i've only seen an fx-chamber up close once. but compared to this pic, it looks correct http://www.x-h2o.com/threads/31921&highlight=factory

FX chambers kinda have a curve in the pipe on the back side closest to the hull while the MOD and Limited chambers are pretty much straight on the back.