Search results

LOL now that's a good one. Wish we had it on film. Mark44

I pack that area with grease. Mark44

Check squish old and new? I run 31cc domes on a ported 62T 195 compression. Mark44

Are you working on an hybrid elec. ski? :shhh:

LOL........... Mark44

Lets see some skis up side down? Mark44

r Not pole position rider body position, the pole won't get any lower than the hood will allow. Mark44

PB2 is closed.

I remember when everyone wanted to get as low as possible now its riser bars....... LOL Mark44

duct tape over the front hole in the hood and block that front air tube for now. Mark44

Here is problem#1 #2 and #3 you may need to move the front air tube to an accessible location and lower the rear tube even more. Mark44

Just fill it with dielectric compound. Mark44

Are your air inlet tubes going down close to the bottom of the hull when your hood is installed? Did you fill the front air inlet and cut open the rear? You do have a coupling cover right? Mark44

r Those were the days.......... Mark44

:puke::dead1:

I heard on the news this morning PB2 is closed due to E Coli levels........ better bring your body condoms. Mark44

6 years on my ADA head with no issue. Mark44

bearings?

Check your squish before and after install. Mark44

Well there you go. Check your pulse line and carbs are they put together correctly. fuel pick up clogged? Mark44