Search results

@mccat @swapmeat @wetsthebed

You guys are shot

Trivial complaint : older men using memes all over this site. Too many memes guys you need to chill out

1990?

My props wear down due to riding in sandy salt water a ton. I have 3 props I rotate and send back to impros. They can wear down enough to cavitate and piss me off in as short as 2 months time. You sure your midshaft wasn't from 1996 and halfway shot to begin with? I've also rebuilt my midshaft...

Problem with a NY freeride is location. We could never drive on a beach, it would have to be more of a "I'm serious about riding, my ski actually runs, I can ride for more than 14 minutes without needing gas" thing due to where we launch out of. I don't wanna have to double tow everyone back to...

I rode the delta in California last week. They had some trails in the weeds.

The prop hex tool doesn't stay on the driveshaft with he prop. You want to tighten it by hand so the motor doesn't spin it on too tight.

Long Island surf > Jersey surf Just sayinn

How does a pump kill a midshaft and impeller ?

There is no ski that is wrench free. Buy something you can afford and learn how to wrench on it. It will only help you out when things do break. If you can't wrench on a ski you will never get far, because it cost too much to pay someone to do it for you.

@BruceSki you have renthal atv high bend. @Yamahah It's not measured in degrees for mx bars it's in mm or something.

Umi steering, milled down the clamp and used pro taper fat bar clamps. I then used pro taper Ricky charmichael bars. @BruceSki 's bars are too tall and it rides like sh it. Hahaha [emoji12]

Yeah

It could be different but I made it out of scrap metal. I bolted my front foothold through the bottom of the plate too because the bulkhead is really thin there.

I cut an inch into an x2 hull and stopped. Then proceeded to stuff it into a rooftop AC unit and get paid for it. @BruceSki

I grinded my 08 nozzle on the top groove only where it was catching the trim cable bracket. You can't over tighten the bolts because there are top hat spacers. You can over tighten and strip the bolts if you tried hard enough though.

Try some kx 65/ktm mini bike renthal/pro taper fat bars

V1 / V2 Got it powdercoated, puts the box far enough off to the side.

So you have the fuel lines in the correct inlet/outlet positions? It should prime quick.