Search results

Man this is an excellent write up. As well as engineering. Not quite sure what I would have done without the internet on this build. Oh wait I do know ....my ski would be boring with absolutely no personality. But thanks to the internet and new friends who are generous with their time and...

@JetManiac He'll dial you in.

What hose is that?

Thanks. It’s powder coat. It called silver vane finish. After the fact, I won’t powder coat another engine. It retains more heat. I didn’t know this before starting the process.

I don’t think I’d have to mod the tank at all. For some reason people cut out the lip area of the hood seal in a couple spots. Not exactly sure why. Superjet tank is easier to get in and out with out removing the b pipe it appears ( I have an actuall fx1 pipe). I was doing some mock up...

What is everyone doing for their superjet tank installation? Did you mod the hood lip area at all? What did you do to keep your tank from rubbing and sliding?

@JetManiac has brackets. I just purchased one a couple weeks ago.

I was able to find some last night, on blowsions website. Last one they had. Perhaps someone else might need them. Thank you.

What tubes are you using here? And how did you mount them to your hood?

Do you still have it by chance? If so I'll take it.

Ah I see. Looks like only one side needs to be cut and extended. Very helpful. I'll probrably go this route. Until I run new flexible tubes. Currently brainstorming on how I'm going to mount and stabilize my tank. Going to glass in strap hooks in sj location, as well as glue down an sj...

Looking for tips for rebuilding an ebox. I have all new components, and will be installing a zeel, and tidy bilg harness. Does anyone happen to have any pictures or instructions? Also looking for recommendations on loctite use, where to use it, dielectric grease, shrink wrap, or must do's...

Is it just a cylindrical rubber threaded insert that screws into the first mount?

Thank you.

Thanks

Anyone have an updated link? The old seems to be gone…

Have most of my tray finished, and will be adding on my layer of 17oz on the rails and tying it into the floor. Here is my starting, and pretty much complete weight, I think I did pretty good. There was a guy that was going to do this work for me initially. I decided to do it myself...

I guess another question I have, is do I need to run faring compound over this stuff? After I’m done laying glass? And do I have to paint for waterproofing? Was thinking I would just turf over the top of direct glass? I’d like to paint my ski. But it will have to wait because I have run out...

So I’m glassing in my tray and rails. I used two layers of 6oz to start the rails, let them get tacky, then lay 17oz over the top. For my tray I’m using 1708 with backer mat. Probably will do 3 or 4 layers. Decided I’m going to do a front foot hood and need to establish the design I’ll...

I wanted to give my tray some extra support, and had to seal in my pump mounts. I dug out the foam around the pump mounts, and prepped surface. I ran all four pump bolts in. I then found some old hose and bored out the id of the hose so I could slide a piece of hose over the bolts packed...