Search results

I just went through this. Replaced everything new oem. Still had a charging issue. Ski ran great otherwise. Swapped my lightened flywheel to stock. Problem solved. I’ll never run another lightened flywheel again unless it’s for total loss. Which also mean I’ll probably never run a...

Don’t seal ride plate with silicone. Will cause cavitation.

Is the cavitation new? Did you happen to silicone your ride plate?

I have one in I have a complete pump, with stock prop, was rebuilt last season with wsm kit. Has a pump seal that comes with it in perfect shape. Would do 180 plus shipping.

What Cdi were you running this with?

@JetManiac has the goods, and knowledge you seek….

Most people seem to ride in Pacific city area.

Looking for another project. Hull only would be ideal, although would be interested in complete project skis as well. Looking for something around the west coast, but if your traveling from somewhere further and would be able to bring ski to my neck of the woods we could work something out...

I have a set that I recently installed on my FX1. They are visual carbon. They are also awesome. I think that bolt on are good for people who are intimidated by fiberglass, or don’t have time to glass Sponsons on. I bought the bolt ons because I wanted to see if I liked them first….and I do...

I need to proofread better before hitting reply. Sorry to confuse you. Get some feeler gauges and get your couplers 2-4 mm apart as shown in manual. Use your straight edge as shown in manual as well.

Yes. You just want them square/inline/centered with each other. This is done without the rubber dampener first. Once you know you’re shimmed properly. You install dampener and shims in correct place. You also one both joint relatively close. To each other so you have proper load bearing on...

Get a cold fusion alignment tool to verify your driveshaft is aligned properly before installing your engine. Should also verify the depth of your driveshaft into your engine bay. You can see where it should be on my build. FX1 Tom21 build. For alignment of your mid-shaft coupler to engine...

To be honest. After swapping out. I didn’t notice too much of a difference.

I had this exact same issue. 760 with A20T zeel, lightened flywheel ( I have all three magnets.) Brand new oem electronics. Killed two new batteries. Putted in a brand new OEM stator. Swapped voltage regulator. Same issue. Swapped flywheel to stock. Problem solved. I believe the...

Thanks for the response. I found someone to make one for me. It’s currently being made. Do you have a link for pictures?

Craftsman hose works pretty good. I picked up some 2 1/2 inch and cut down some of the stock tube that wouldn’t allow me to close the hood. After cutting one end of the hose I stuffed it into what was left of the vent tube and noticed that it was practically stuck in there and had to work it...

Bump

I heard he makes the m. Actually bought a ride plate from him that works great. Would like to get one from him. But was unable to get in touch with him, and didn’t want to bother him. Feel free to drop me a line if you’re able to make one for me @TOBY. Thanks @Big Kahuna

Looking for a chin pad for 08+ sj pole. Who makes a good quality aftermarket one? Looking for something composite probably. I have straight bars and -2 Cold-fusion steering. Thanks.

Man that would be fantastic. I have the 96-07 cable, with the bracket to be able to run on an Fx1 or 08+ stock pole. Its already been installed. Currently waiting on my x2 nozzles to arrive. Thanks for helping us peasants out Flash!