Search results

yes, it does have a much smaller diameter hole .it will open under the correct amount of pressure created, adjustable by twisting it in or out, either increasing or decreasing the spring pressure against the slug, just like a jetworks flow control valve, except functionally the opposite. the...

.... this was a split design between me and motorheads. the slug in the center has a pisser hole drilled down through the center keeping water at a minimum, and the rest of it is like a mesh. when the water pressure increases, it moves forward off of the conical area and lets a full flow of...

thats what the thing in post #2 is for.....

I like the 650....lol

well, they probably looked at the direction from which the spud made contact with the lady's car, then went over into the area where they though it originated from, started asking question to pissed off neighbors that were getting tired of hearing "KaBOOM!!!!" around their houses and apt.s every...

yeah, it didn't want to start, so you pissed it off...LOL :P

and were you the brains behind the whole scenario? or did it just "poof" all by itself?....lol : )

I mean, wtf were you doing to cause the flamable material and sufficient amount of oxidizer to come in contact with a friggin heat source?.....lol I guess I'll have to be far more direct with my questions from now on, dustin....LOL

how did it catch fire?

ditto that. I will be glad when I am too.

how much have you payed for the ping-pongs balls so far?

well, you were, sir. ...but I was "right" before you were....lol :P I just changed my mind like a dumbass. also, your reasononing for your assumptions weren't on a very "solid" base...lol like I said I've had bearings and cages go and not just d!ck up the outer edges of a dome. I've had a...

yeah, they're not really good for anything except causing problems. I guess you could use one for defensive purposes in an emergency...lol

man we tried to launch a potato with it one time and the cans separated under the combustion. the real potato "spud" guns we used a pvc setup with a 4 1/2 ft. pipe for the barrel, unscrew the back and pray right guard deoderant into the chamber and close it off, then take a potato and force it...

yeah, it needled a break. : )

we used to make tennis ball launchers that worked that way. put in a couple drops of gas into the top, shove a tennis ball into the top, shake it around a little to get the fumes stirred up good, and light a hole at the bottom. kaboom. tennis ball goes out of site....lol

until after about 9000 rpms.. and some nitro and alcohol....LOL

well, I guess i was right the first time...lol oh well at least I had my bases covered. : ) still, usually when I've had a needle bearing take a holiday like that, it jabs the hell out of the entire surface of the piston, not just the outer edges.

what do you think about installing a couple of tire inner tubes with valve stems sitting out somewhere instead of ping-pong balls?