Search results

Frosty's steering setup sure is ganster though :purr:

An update: All turnplate have been shipped out, FedEx should have or will be sending out e-mail confirmations. Sorry for the delay.

To everybody that has ordered a turnplate within the past 2 weeks; we are sorry for the delay. Our bars are made in Washington State, which is just one of the processes that we go through to provide you, the freerider, with huge savings. Sometimes we run into a hick-up along the way, again we...

Sadly, we are going to have to start charging a few dollars more for shipping. For the past couple of weeks we have been starting to pay out of pocket for shipping. It has gotten out of hand with how expensive it has become to ship anything these days.

right on :afro:

they do make awesome power for the cc but man do they weigh a ton.

jetpilot08...We are not sure if the steering systems work on 08 Superjets as I have yet to see the holy grail in person. If somebody were to buy the setup for their 08 Superjet and it does not fit we will buy the system back and refund 100% of your money! So please, do not fear losing any...

IDOK, we will sell the turnplate cheaper if you do not desire bars.

straightbar turnplate system :biggthumpup:

Chris, sounds like you have a pretty mean 650 setup. Your best bet though would be to save up for a 61x cylinder setup and port the coffman exhaust manifold. I pretty much had the same setup on my square nose you are running; than did the 61x swap for 400 dollars including...

update: Shopping cart is now up and running. We have turnplates IN STOCK and can ship within 24 hours of your order, no wait!

Keefer is spot on! It comes with everything except bushings and bar clamps, also includes a 3 page install instruction packet with picture when shipped so you don't have to print one off our website! Everything is overly built, ready for some beating! As for the throw. It is a quick ratio...

Sorry for the confusion. You DO NOT need an expensive bearing. You re-use your stock bushings and bar clamps. The system is Solid! If you go to the website, you will see all that is included, its a sweet setup for not a lot of money. Don't let the price fool you, it is great quality. I...

Yes it's true. You can have a -2 or -4 inch (shortest on the market) straight bar turnplate system from Invert Technologies for only 80 bucks! Over half the price as the competitors, and has had great reviews from well known riders on the X. They have been for sale since November of 2007; I'm...

Frosty that is great! And so it begins, next..front page of the sports section in the local paper. I'm callin it right now!:fing02:

If you need a place to crash I live about 45 minutes north of Atlanta right of I-75 if you go through that way.

wow! I just now saw that, very cool! Thanks to whomever set that up for the freeride.

cut it off! Mine was was cut -4 inches from stock, that was half the point was to get your pump cone out past the hull.

The zinc offers Moderate rust protection, though it is not as resistant as stainless, it is difficult to find stainless steel bolts with a strength rating. Safety was our main concern but if rusts poses an issue we can offer a stainless steel setup.

For those with concerns, There is no metal to metal contact in the steering because it re-uses the factory bushings; which are proven not to wear out or corrode in salt water. There is no slop in the steering system because it uses two jam nuts to set your desired bar tension. The...