Search results

those are quite rare, its the famous yamaha-kawaski zxi model.

make sure the check valve is good and seals by holding a finger over the hole on the flap side and blow into the flap and then suck back. if it lets air thru backwards its crap. I just found one that had some crud growing under the screw and plate but looked spotless everywhere you could see...

I just did this install and called for the instructions, Im not positive but I think you did it right. the inlet is on the bottom of the manifold. the rear of the pipe about midway goes to top of head rear. the inner middle fitting goes to stinger.(pipe to pipe) and I think you can tee that...

one time I had the high speed check valve(little plastic flap) fall off due to the screw breaking. on the dual its sound like you may want a new needle and seat on both carbs. do not replace the oem springs! leave the ones that are in there.

lol only because I have tried to work around problems before too! trust me I have got to be the laziest short cut taking, f it - it will work guy when it comes to my skis. In the end we all know its best to do it right. Im just worried there is some corrosion and its not sand its water in the...

bad fuel, water in fuel, pickup tube clogged broken or missing, bad fuel switch? you tried everything else but didnt mention what you found on this.

its worth a try but I dont think its gonna work. that sand settles pretty tight and when it dries and the crystals grow its almost like rock. the water pressure will not be focused to the point it will move anything, maybe a small amount from the top that is already loose but if that is full...

compared to stock pricing you are getting the hookup.

I want 2 in L. advance notice on when to send money helps with the ebb and flow of my checkbook lol.

that is the yamaha setup. Bonzai bob did it for them originally.

I have read all the threads, and I see lots of glass work. how is that easier? I see nowhere on how to correctly line up the pump. just sticking it in is not gonna cut it. with the yami setup the shaft can be centered to the hole in the hull and shimmed to be centered. as well as the...

that may be easier to install but how did you align the pump?

no rust on you brother!

you are better off to just start with the sj. save a little more or get a square.

I see what you want, I will make it happen.

ok? OK?? that turf looks excellent! damn go easy on yourself.

bingo, and fyi jetmaniac is selling modded couch driveshafts. maybe he has a beefier part for you. you will still need to align it or it will damage that one also.

yes. and I have seen then vibrated by what I can only imagine was a loose mount and just wallowed the insert out of the hole. I just dont understand why its soo hard to spring for new mounts? when they are 100 each or more then I might think twice about another method. most of the time...

that like a scratch! wtf? put a papertowel and some tape around it and get back to what it was you were doing. unless it was drinking and throwing a knife at your ankle.

if you want a glass one to experiment with I can make one.