Search results

One thing the Ninja's didn't have were primer fittings and I'm not adding them. I hear all the rage is choke cups, so I'll give them a try. If they don't work, they will be great for storage.

With the carbs jetted fuel lines were next.

And for $5 dollars at WalMart the best 5 bucks I ever spent for dealing with jets. Next to the $5 for the pill case.

Jetting the Ninja SE 50's. Came with 110 MJ , 145 PJ, was given a suggestion of 122.5 MJ and 150 PJ, so I'll start there and have everything around that on hand. Oh yeah, 19 psi pop-off.

Had to wait a week for these, BSPT hex plugs. Anyone doing their first Bun, those NPT fittings aren't tight, THEY'RE WRONG !!! Buns are all BSPT, British Standard Pipe Taper ! Get the right fittings !

Finished up the cooling lines and added Ebox. No matter how hard I try friggin engine compartment always winds up looking like Das Boot. Oh well, function over form. I usually observe metal clamps on metal fittings and plastic clamps on plastic fittings, the head pissers were the only place I...

I'm sure all the stuff out there is comparable or it wouldn't be on the market for long. I wouldn't open a tube of it for just doing inserts though, but you can't beat it for a big bonding job like top decks and bottom decks.

3/8 NPT threads are .675 OD. As general rule of thumb I like to see what I’m tapping as thick as my OD. But this is jet ski stuff where general rules of thumb go out the window….. I’d ask Push what they think about going that big.

Unless it’s made with bosses 3/8 NPT may be a little too big for tapping just the wall.

This is a POSITIVE!!! Keep this club exclusive, let the u-tubers, facegramers, instabookers and tweetertockers stay right where they’re at. Nothing wrong with a nomination/voucher system.

The results convinced me that I didn't need Plan A Or Plan B Or Plan C The test convinced me Plan D, Two 1/4inch thick o-rings would suffice.

I did perform some HIGHLY scientific research on my battery tray, lol. I bounced it up and down from a shock cord upside down after installing the turf bed. The holes do more than lighten the tray, they help to lock the turf in.

Only the pinch bolts are Ti. Less selection with Ti and I obsess over bolt thread and shoulder lengths when it comes to fit. Probably would've taken me another 5 years just to collect the right bolts in Ti ! Just went with 316ss. I will admit, I did consider it!

THANKS !

Thanks g-ski! Be sure to post pics of what you were inspired to build ! Everyone luvs pics !

Add the hood straps and ratchet, and the hood is done!

And since I had the chip brushes and contact cement out to turf the pipe, I glued on the hood pole pad. Nothing like intentionally scuffing up beautiful visual carbon. Still better than the pad falling off and the pole crashing into the hood.

On the advice of someone who couldn't get his Bun tuned because he found an exhaust leak from steering cable rub AFTER he pulled his Bun, I turfed the front of the Bun pipe and used an eye nut with one hand cable ties to pull the breathers as far forward as possible.

I'm going with SE 50's, pump gas domes to start with. PM sent.

How's it going Max ! I'm a newb to Buns and 1200's so I'm going on the advice that I have got from a couple of guys who know a lot more than me running them. When I first got it I was advised to at least drill the manifold and plug it in case I need to add it later. Since getting my beginning...