Search results

OEM Yamaha carb off of any 650 or 701 61X motor .

and if you do it right it makes a song , I get high when I hit my bong and it just goes on and on and on

In beautiful downtown Wetumpka , Al . ( I call it Wehonky ) , on the Coosa River today water testing this Waverunner XL 760 I built the top end on , it ran flawlessly , Doug's house is right around the corner so I dropped it off there for the customer to pick up tomorrow . What you are looking...

You are good to go , just swap the carb .

Better to foul a plug than buy a jug .

It's a Yamikawi Superjetski .

You said you rebuilt the carbs, needle and seats don't come in the Mikuni kits , did you replace them or check the popoff pressure to make sure they were not leaking ?

Does the top of that carb have three bolts or four , if it has four tou are good to go, if it has three you will need another manifold , I can't tell from the pics .

Usually a leaking needle and seat cause this .

Two things a jet ski won't run correctly with are exhaust leaks and fuel leaks , each contaminates the air the ski is running on and makes it run extremely rich , an exhaust leak will make it cut off completely , the red thing is called an Aquamuff, it is a silencer , you can take it off and it...

Std pistons are 75mm so add whatever dimension your cylinder is bored to , lets say it is now 75.75 mm and it needs to be bored again , you would need 76mm pistons or 1.00mm O/S . Your best bet is to take it to the machine shop and let them tell you what size pistons you need , as far as the...

2021 Honda Accord sport , she bought it new with every warranty they had except for the paint coverage, it this the only thing that has ever gone wrong in 4 years of owning it , I am not complaining , I am sure one or two battery cells shorted out because it gave zero warning and the voltage was...

I cleaned it up and sanded it with 800 grit to get rid of some of the nastiness , I put a few stickers over some holes in the hull in various places , I didn't really try to cover up any of the war wounds , it's a survivor , it's been put through hell and it shows . After sanding I hit it wit...

There is about a 14 year gap here because I was banned for over 10 years , so it is what it is , deal wit it . . The tubbies were put on , the back was chopped , steering was changed and so on and so forth , I also knocked a hole in the bottom at one point riding it in a small pond and repaired...

No I only built this one fixie 300SX , I never got around to putting a bigger motor and pump in it , I am seriously considering splitting the 650SX fixie and this ski and building it that way , the 650 already has been shortened ,it has a good pump and impeller and all the cooling lines are run...

Ok thanks for the confirmation on that .

MSD please expand on that , is it not running a SBT CDI unit or is this something that you swapped into the machine ?

I am just the opposite , I am thinking it's not electrical , usually when it's electrical it starts to skip , bust up , miss whatever you want to call it or it gradually loses power and gets slower and slower till it cuts off , none of this is happening from what I have read here . That MSD...

I pulled the e-box apart after it stopped raining , unbelievably if was fairly clean , a broken glass fuse was the electrical culprit , any way I just pulled the red wire from the solenoid to the start switch and touched it to the battery side of the solenoid , it spun over nicely , then I...

I honestly don't know when the last time this thing ran was , last time I checked I had no power to anything , so to get to the electrical box on this you have to remove the fuel tank , the vent hose that goes by the carb and the carb , it's really tight working space in here , at any rate all...