Search results

I agree the Sato Engineering throttle lever worked well without all the sharp edges but I believe it only came in silver and blue colors.

Why do you need sleep?

Yes... wax you're carbide burrs so they don't load up with aluminum. The exhaust manifold should be bored out using a mill for accuracy so you don't hit the water jacket area and a 2-inch coarse flap wheels works well for porting deep inside the head pipe where most the restriction is located.

The Kawasaki stainless studs and acorn nuts work well with the Yamaha cylinders but they're a little pricy. I'd be curious to know how much the ADA kits are selling for and if it's all stainless hardware.

The steeper angle of the Raider reduction nozzle cause interference problems with the trim bracket and welding the new trim pivot points back further on the nozzle tip increases the travel distance. It also allows the use of different reduction nozzle models that don't necessarily have the trim...

That's true and media mail if you're a real cheap azz but if you make you own labels using the web site, you won't have to stand in those long lines at the post office.

You should register online with the USPS web site because it's cheaper and it includes free delivery conformation along with the history of all your shipping transactions.

I'm sure each reduction nozzle that Yamaha develops is specifically engineered for their skis by the engine power to weight ratio, pump size, impeller type & pitch, hull design, top speed, drag etc. Most of their jet-ski's with smaller displacement engines that weigh less use the steeper...

That's normal because the squish depth on the cylinder head is quite a bit deeper at the rear cylinder.

I was told from a reliable source that the 760 engines have different timing curves for each cylinder that is control through the CDI's electronic circuitry. Even though the coil has the secondary leads tied together it can control the timing through the primary wires. If you notice on the...

X3 Make sure your wear gloves using that stuff in a well ventilated area.

Those are couch impellers It would have been cooler to use a dual counter rotating impeller setup.

They're different: http://wiki.answers.com/Q/What_are_the_differences_among_short_circuit_open_circuit_and_closed_circuit

In an electrical circuit with resistance shorts can be either open or closed. Open = No Current Flow Closed = No Resistance :chairfall:

Solid core non-resistor plugs won't short out unless they have cracked insulators or they're fouled out. It very common for the resistor plugs to short open especially when subjected to a marine environment.

Why don't you guys start using non-resistor solid-top plugs if the resistors are shorting open?

I might end up making a set for the 08+ SJ but the longer length won't meet the requirements for exporting and racing regulations.

You must have a larger throttle wheel on the carbs because it works just fine with the Avid speed dial 5 & 7 mid-levers and ODI grips. The after market lanyard kill switches can be mounted just about anywhere accessible and can be found inexpensive on fleBay. I have my switch mounted in the...

It appears like the ski took off real quick when the white wash came through and it remained right side up? A couple words of advice would be swim quicker & foot straps.

You should drill & tap your welded bung fitting for a stainless 6mm bolt & nut to make it height adjustable. You can also offset the steering nozzle holes for use with larger diameter bushings so the nozzle is pointed slightly upward and the trim ring is point more downward. This will make...