Search results

THIS! We can debate how rules should be changed all we want but none of it matters really. What needs to change is the way the sport/hobby is (well, isn’t) promoted. We have a chicken and egg problem. Stuff is so expensive most people can’t do it. Prices won’t go down until there’s more people...

Lower pitch is ok too FYI. I’ll likely test this setup on an XS1200/DVX or 1015/DVX

Hey - doing some experimentation with a home made pump and need a 160/83 impeller somewhere around 10/20 pitch. Will be bending and testing so somewhere close should be fine. A little damage/etc is ok as well. Thanks!! -Jordan

Tell us more. Dunno much about waterproof ratings. Is ip66 not sealed to humidity or something? PS - an AG battery isn’t sealed really at all. They sorta glued together with what seems like super glue and really nothing seals the terminals.

Those batteries look amazing. one of the reviews says they are IP66 waterproof. Anyone confirmed that? Please post once you get/try them. These AG1601s we are all running are pretty terrible products...

Just run the exact curve you had on the MSD. It will perform exactly the same. Make sure total timing is in by 1500-1800 rpm. If you aren’t sure what’s on the MSD you will have to measure your static timing and then check your dip switches against the MSD manual. Happy to help if you aren’t sure...

Your pretty much guaranteed to fight that setup. They will be constantly coming loose. @tricky1 sells the heel locks with wedges all as one piece I believe. Mine are old and beat up and I’m really hard on turf do i installed foot straps over the sides to hold them in. The side part is almost as...

I’d bet reliability will be identical to that of the other zeel products. The only major change here is how he’s getting the trigger signal and a more robust programming cable. I think there’s enough zeel boxes out there at this point that they have been proven to be extremely reliable.

andddddd it looks like they either don't carry it anymore or are out of it. silicone hose section has nothing in it. WTF!!!

Flex technologies is the best stuff i've used to date. The black is kinda gray, but who cares. https://www.siliconehose.com/

I’m not buying anything ET FYI. I was just curious because of something he said to someone else so I messaged him

Ya who knows? Maybe there’s someone different doing them outside the US? All I know is I asked mark “are you taking over ET” and he said yes

He said he is now ET when I asked him not too long ago. Don’t think he’s up and running yet and pricing is going up a bit from what he said.

Haha totally. Very thankful that there was something to watch. Would be nice to have the drone YouTube feed again though.

Anyone know if there will be any live feeds from world finals this year? Kinda sucked last year watching just IG live feeds and such.

https://www.ebay.com/itm/Yamaha-1997-1999-GP1200-Jet-Pump-Drive-Shaft-/124808274232?mkcid=16&mkevt=1&_trksid=p2349624.m46890.l49286&mkrid=711-127632-2357-0 They are cheap on eBay. Get shaft cut by @Sasquachcrap and get bearing kit and wear ring from @JetManiac

Yup

Disconnect start connector at Ebox and short it with a piece of wire. If it turns over, start stop switch is likely bad.

pop off ridiculously high could cause this. are the arms bent at all going to the needles? they should be basically straight but if they are very bent it could prevent the needle from ever opening. dumb question, but are you sure you have the feeds hooked to the correct spots on the tank? two...

Yes