Fix for b-pipe rubbing

[DC SUPERJET]

Has anyone figured out what a good material would be to put between the b-pipe and the inside of the top deck to prevent rubbing?

I was thinking turf, but then thought that would most likley melt.

Any ideas?:dunno:

 

[BruceSki]

turf works great


im going to put some on mine this year since its just been rubbing through my reinforcement all of last year

 

[Idok]

turf

 

[sflsurfrider]

turf is the duct tape of standups

 

[DC SUPERJET]

thanks that was quick

turf it is

 

[oxnard111]

turf x 5.

i have been just contact cementing it straight to chamber. has been working out very well.

 

[DC SUPERJET]

ok great, even easier

 

[DezKnotz]

turf works tits

 

[Freakrider]

someone say turf again....

 

[THRUST]

thin rubber you can get at any hardware store in plumbing dept . turf only will last a ride or so

 

[BruceSki]

thin rubber you can get at any hardware store in plumbing dept . turf only will last a ride or so

my buddy put three pieces on his square and it lasted all last season(we removed them to reinforce and put them right back on over the reinforcement)

it doesnt make the pipe get all that grey metal mush all over the engine bay from rubbing directly against fiberglass.

 

[Mark44]

Hammer time!

Mark44

 

[yamanube]

turf

 

[WaveDemon]

turf.

I use it for reinforcement.

 

[oxnard111]

another good thing to do is to lift the inlet side of the water box up with a secondary pad or a couple layers of turf.

as said before i have had turf on my chamber for over 1 season it is still holding up well.

 

[BruceSki]

I use it for reinforcement.

thats great.

 

[tightithrash]

from reading this i think every one agrees turf is not what you shold use.......
















haha

 

[OCD Solutions]

I will be using turf, heat isn't a problem with a carbon chamber.

 

[Troublemaker]

biggest hammer you can find

 

[yamanube]

I will be using turf, heat isn't a problem with a carbon chamber.

Dont do that!