Wear ring

[KID'S JET]

Hey guys in the middle of this on my 15 superjet
I’m checking my clearances with the old prop because the wear ring is not looking so good . I’m getting about .028 in some spots. Should I check it with the new one in or is that to far out and it won’t matter .

 

[KMN]

From the service manual:



Up to you at this point. You could get a new wear ring while you're installing the whole thing to have that piece of mind, but would probably work just fine with your old one.

 

[JetManiac]

Hey guys in the middle of this on my 15 superjet View attachment 413291
I’m checking my clearances with the old prop because the wear ring is not looking so good . I’m getting about .028 in some spots. Should I check it with the new one in or is that to far out and it won’t matter . View attachment 413292

Your old impeller is worn and you are measuring the wear off of the worn prop edges. Build pump, install new prop, install wear ring, check it again.

Check out wear ring info in post #3 here:

Ski - PUMP PARTS-Driveshafts,MAG/OEM pump,Props,Wear Rings, Pump Shoe, Intake Grate, parts

JetManiac's Pump Shop Driveshafts New SuperJet 1990-2007 length a/m driveshaft $300. sale 229.80 New Superjet 2008-2020 length a/m driveshaft $345. sale 259. New WaveBlaster B1 1993-1996 length a/m driveshaft $300. sale 229.80 '90-'07 SJ length nontapered HD recon. driveshaft 219...

www.x-h2o.com

 

[KID'S JET]

Thanks I ended up looking through that before you posted it.
I got the shaft out today out of the old pump and I’m seeing what it looks like three seals but I only received two am I supposed to reuse one of them

 

[JetManiac]

Thanks I ended up looking through that before you posted it.
I got the shaft out today out of the old pump and I’m seeing what it looks like three seals but I only received two am I supposed to reuse one of them

The first one is an impeller spacer washer, not a seal.

 

[KID'S JET]

Ok thanks so I reuse that one