CarFanatic
Fiberglassing Newb
- Location
- Cincinnati, OH
I"m about to pull my motor to put all my parts on. This will be the first time pulling my sj motor. Wondering if there were any tricks or tips!
undo the elec box from the mounting tabs, lay it over the head ( it rests between the plugs) remove battery cables, remove the colling line fitting(s) at the bulkhead, start stop and kill connectors disconnected, remove fuel lines, remove throttle cable ( and choke if equipped) disconnect what ever exhaust you have to either leave the manifold, or manifold and head pipe if you choose. slide forward, lift out (make sure cables arent snagged on anything)
and set it on the work bench.
I"m installing
msd enhancer
b pipe
ada head
tbm flywheel
reeds
If that's all the parts you're installing, I would leave the engine in and just pull the gas tank and e-box out IMHO.