Superjet hull wieight??

[FL-cracker]

I would agree, since my never seen the water hull started at over 110lbs...

Take out the foam and you are around 95lbs:biggthumpup:

Note: If you dont put foam back in your boat make sure to reinforce tray area "inside". I did only one layer of Kevlar, and it wasnt enough. I had a fracture I repaired in the right rear upper corner from doing roles at Daytona...... the fracture didnt go all the way through......it wont happen in that spot again........ it also could have happened from someones boat slamming into mine on the beach too? Not sure.

 

[Rickster]

Take out the foam and you are around 95lbs:biggthumpup:

Note: If you dont put foam back in your boat make sure to reinforce tray area "inside". I did only one layer of Kevlar, and it wasnt enough. I had a fracture I repaired in the right rear upper corner from doing roles at Daytona...... the fracture didnt go all the way through......it wont happen in that spot again........ it also could have happened from someones boat slamming into mine on the beach too? Not sure.

Foam is definitely going back in...:biggthumpup:

 

[WaveDemon]

Foam is definitely going back in...:biggthumpup:

why do that when you could use hellium filled inner tubes? right cracker?

 

[FL-cracker]

lol.... gona pull any backys this weekend Tim?

 

[WaveDemon]

lol.... gona pull any backys this weekend Tim?

maybe, I'm working on some stuff.

 

[Idok]

my fx1 with hood no pole and a little misc. hardware was 92 lbs....

roundie was like 125 before wet foam removed, with LOTS of reinforcement but no hood or pole...some hardware