Special Coupler between bpipe and waterbox?

[Fro Diesel]

I am installing a bpipe in my sn, there is foam between the waterbox and the nose of the ski. The rubber pipe is way too long, is there some type of special coupler you guys are using to connect the chamber to the water box? Stock sn waterbox, for now. Should i just remove some foam and slide the box back?

 

[surferdude345]

ON a RN you just cut the stock hose. Im assuming its the same with the sq

 

[Matt_E]

It is.
Or you can use the blue FPP coupler ($50), but I've had better luck with the stock hose.

 

[WAB]

That's a thick hose. A razor blade won't do it. I had to cut it with a sawzall.
Of course, I love any excuse to get out the sawzall!

 

[2006superjet]

ya

that blue silicone bent tubing connector was a lil long for me to you can take steak knife and cut it dont but dont do it to much like i did and not have a lot of play in it for the hose clamps. dont use wd40 to lube it either. the stock one may not fit cause it is a larger tube than the stinger and it would bend it and not make a good seal but i could be wrong. could build the stinger up to size with a cut off piece of blue fp hose.

 

[227]

The FFP blue reducer exhaust hoses tear easily. Just cut down the stock rubber exhaust to length. Jet Ski solutions sells an aluminum spacer that fits the end of the Factory pipe chamber so it has the same diameter as the stock exhaust hose. Do it- you'll never have any problems again.

 

[Fro Diesel]

thanks i am going to check out jet ski solutions. then cut my stocker.

 

[demolition_x]

if you have a square nose the b pipe outlet should be 2in like all the exhaust hose in the square.

you just need to cut the stock hose, you don't need the aluminum spacer jetski solutions sells.

 

[WDKfan]

I went to napa and got some Exhaust/radiator hose(cant remember) that just fit over the b pipe end and it worked perfect for me

 

[Gainera2582]

I have what you need:

http://www.x-h2o.com/threads/27716


And it holds up great. Just make sure like all fittings that you clamp them down so they dont leak!!!!

 

[hermanns]

Just cut the stock hose down and double hose clamp it on

 

[Fro Diesel]

I am going to try the cut stocker first, then i may take that bpipe coupler later. Sorry for the interest though pm bro.

 

[hangtime]

hook the bro up and give him a good deal

I have what you need:

http://www.x-h2o.com/threads/27716


And it holds up great. Just make sure like all fittings that you clamp them down so they dont leak!!!!