Sparkplugg wire ???

Wolf Child

Wolf Child

Just Another Octard
Location
All over C. FL
dirkdiggler said:
Tags keep getting more un-realistic! "dirkisahomo"?? who "sleeps inside" one of the hottest girls on here and who has one of the most sought after skis made, FX-1 fo life!
And most important, who has piles & piles of $$$$$$$ because they "cut back wires"??
HA!
Click to expand...

X2 RAGS said:
dude its post like this that let us all know you are a tool.

your girl is cute, but far from the hottest on here and we just all feel bad for the fx-1.
Click to expand...

I wouldnt go that far. he has other posts that make it far more obvious.
 
dirkdiggler

dirkdiggler

Vendor Account
Location
WI
Mark44 - I was talking about beauty on the outside NOT inside! JK

Wedoseado - I am selling the rail kit and just buying another complete sheet, I need more anyways.

Vitaly - She need not worry about knocking her teeth out on the Superjet because I will end up knocking them out long before riding starts.

azreark1 - I put it back on and used some of the super thick grease JSS sells, there wasnt any sealent behind it anyways, the rubber seal seems good! Didnt say FX-1 was best, just that its highly sought after!!!! That is my bike in the picture. Its a 2001 GSX-R 750 that I bought it for super cheap with all the air brushing and had to swap the bad motor out of it. The pic I posted with my girl on it was the picture I used to sell it!!!

I have some many toys/$$ because I buget well and look for alternative ways of doing things!! I will never buy anything unless I know I can make money on it, car, bikes, jetski, house, paintball stuff, rims and the list goes on and on!!
 
dbrutherford

dbrutherford

Parts Whore
Location
Fairmont, WV
If you look in the pic on this auction, there is a connector that you can use to connect two pieces of spark plug wire together.

http://cgi.ebay.com/ebaymotors/ws/e...viewitem=&item=180229715394&_trksid=p3907.m32


I believe NGK sells them and Parts Unlimited sells them. I was considering using some of these because my plug wires were not long enough for my engine swap I am doing. Well I have since decided to not do so for obvious reasons that everyone has been telling you.

The best method is to complete remove the coil wire from the coil and epoxy in your new wire. There is a metal pin/spike inside the round place on the coil where the wire goes in. I know, I accidently ripped a wire out.

I know sometimes people give others a rough time on here but there are years of experience between everyone. I can look at a username and know if they are full of it... knowledge or BS. Try and do the same. you certainly are not earning any browny points lately. The search is also a great tool. Ask questions only when you have you can't find it searching. Threads like these keep getting repeated over and over again because no one searches. I see it happening with X2's all the time.
 
ski4

ski4

gonzo
Location
cleveland
on the subject.

a long time ago i was in a pinch.
cut the wire back but things got too short. i had to splice to ride that weekend.
so i cut the wire in half, stuck in some coat hanger
slide the wire back together with a wire off an old coil. , lots of tape and walla.
it worked in my old 750 for like 2 yrs till i got my enhancer in it. i don't think i would do it again.

actually that coil got pulled apart and some new wires were put in the right way and it's in my superjet now lol
:biggrin:
 
You must log in or register to reply here.
Top Bottom