How to strip the paint off a ss fpp chamber?

[Dustin Mustangs]

I just got a blaster limited chamber to try out and I wanted to pretty it up a bit before I run it. I was hoping to get the original factory pipe applied paint (?) off but it is putting up a pretty good fight. Last night I tried that aircraft paint remover stuff and it took some of it off but in certain areas the finish just wasn't affected even after multiple coats and tons of wait time. I've seen these bare before... is there a slightly more aggressive stripper to try or do I have to grind this bs off?

 

[Shifty]

You may have tried this already, but putting Seran wrap over your coating of stripper will keep it active longer and speed removal.

 

[stanton]

get a paint stripper wheel on a grinder, they kick ass for fiberglass work too!
http://www.acehardwareoutlet.com/(qjkxcv55nvwyid3bk1ruxfq0)/productDetails.aspx?SKU=2103026
somethin like that

 

[SUPERTUNE]

Stripper wheels are needed as aircraft stripper will only get you so far...

 

[#ZERO]

Take the pipe to a ceramic coating place and they'll acid dip it.

 

[Dustin Mustangs]

Thanks for the replies, I am going to try that stripper wheel tonight and see how that goes.

 

[Fro Diesel]

hmmm strippers. :brap:

 

[FyrHazard]

Stripper wheel works pretty well, especially if you warm the chamber up a little.

 

[Dustin Mustangs]

She worked like a charm. Took about an hour or so.

 

[Idok]

Stripper wheel works pretty well, especially if you warm the chamber up a little.

strippers ALWAYS work better if you warm them up a bit first :Banane26:

 

[wayne]

i have posted this a couple times and swooperjet posted it again after he tried it. check out his thread about it. best stuff out there, even for cleaning you foot tray after deturfing. just don't get it on any paint you don't want to remove.

http://www.x-h2o.com/threads/51994