Bud Productions 09 SuperJet

[BudProductions]

So I started messing with the SuperJet I'm starting off with installing some rickter footholds that I got off an X member for $75 and I picked up a snow camo turf kit. Also hooking up a 750 rulemate bilge

where to you guys put the bilge on superjet, does this located look like it will work?

I got the footholds glued in thurs now for some foaming and glass

 

[MADMAT]

MMmmmmmm....so clean and fresh! I think most people put them back by the mid shaft because then they are not in the way when you pull the motor and tank.....but that looks like it ain't happening for quite some time so anywhere should be good. And it looks like you will need hardly any foam at all.

 

[guiness92]

I would put the bilge in the back by the midshft like mat said, when the ski is either sitting on the trailer or moving, the water builds up back there and puddles in that spot, so thats where you want the bilge. and the is also nothing in the way.

 

[Idok]

snow camo?


its called Moocow!

 

[nokfir]

are u turfing over the top rail pad?

 

[BudProductions]

So I'm just about 98% done and I'm real happy with the install looks pimptastic!
here are a few pics of my end results, going to rip it tomorrow

 

[BudProductions]

MMmmmmmm....so clean and fresh! I think most people put them back by the mid shaft because then they are not in the way when you pull the motor and tank.....but that looks like it ain't happening for quite some time so anywhere should be good. And it looks like you will need hardly any foam at all.

yeah I made a bit of a mess with the foam poured a lil to much

are u turfing over the top rail pad?

I was going to but then decided against it