Any tips on putting my new HydooTurf on before I F-it up?
- Thread starter 18racing
- Start date
Idok
F1pro
- Location
- Nations oldest muthaF+++kin city
measure twice, cut once
when you think its ready, go inside drink a beer and by then it MIGHT be ready
dont be afraid to use heat
when you think its ready, go inside drink a beer and by then it MIGHT be ready
dont be afraid to use heat
What he said, beer, heat, repeat...
madscientist
chilling with these guys.
- Location
- good old p'cola
shape, stretch, and form. if you do slightly burn it just sand it off, it won't show. gloves a must.
on the x2 do the foot wells and side rails in 1 piece.
on the x2 do the foot wells and side rails in 1 piece.
CD155MX
Squirrel!!!
- Location
- Alta Loma, CA
Don't rush it. Take your time and make it look nice.
- Location
- Grand Rapids, MI
What they said.......
Take your time
It's better to cut it big and trim rather than too small.
Make sure you wait long enough for hte contact cement to dry(I put 2 coats on the turf and one on the ski)
use heat gun and gloves to stretch slightly around curves.......2 people helps a LOT for this.
Did I mention to take your time???
Oh.....the beer thing helps too.
Take your time
It's better to cut it big and trim rather than too small.
Make sure you wait long enough for hte contact cement to dry(I put 2 coats on the turf and one on the ski)
use heat gun and gloves to stretch slightly around curves.......2 people helps a LOT for this.
Did I mention to take your time???
Oh.....the beer thing helps too.