Search results

nice ski...wish i wouldve started with something that nice

nice....good onya for givin the 650sx some love

will it run with the hood off (i.e. exhaust leak)

thanks...appreciate it

hoping to get it on the water to tune it this next weekend big thanks to jetmaniac for the parts and info and pro-tec for the pipe help

engine...

steering...

and some of the changes...

finally finished up the couch build. as a reminder, here is what i started with. wasn't anything wrong with it, just needed some updating to get rid of the 90s paint/graphics and them some parts were thrown at it for good measure and the result

you cant send jetmaniac a message until you have 5 posts...until then, find one of his threads in the for sale section and reply to it...he will reach out to you and get you hooked up

need some more info...what elevation are you at? i see you are in saudi arabia so i would guess around 2000 feet (650 ish meters). what octane fuel will you be running? here is a screenshot form the ada site that shows dome vs lbs vs octane. this is for sea level though, so you will have to...

got quite a bit done recently. prime and prep was pretty easy, but i am a better sander than painter. i am sure alot of it has to do with technique, but the total boat topside isnt the easiest paint to use. takes quite a bit of pressure (and 20% reduction/thinning) to spray it. in the end i had...

i would go for one too

Early miata with a hard top?

If you aren't necessarily looking for a project, check out the scarab 165id. Was my first boat and it was a blast with the 250. Originally I think it was a seadoo hull (speedster?) and benetau acquired the design and started putting the supercharged 150 and 250 rotax in them. Alot of people...

there is a post about a 94 wr3 showing the same symptoms. http://greenhulk.net/forums/showthread.php?t=297241&p=3164853#post3164853 in addition to the fuel suggestions, there was also a suggestion about the waterbox (baffle breaking loose and choking the exhaust) you said the pink wire is...

primer is on...now back to sanding totalboat 2-part epoxy primer gray base hull above the bond flange white base hood and hull below the bond flange

better option for the steering cable... was now

couple of small mods prior to painting... replaced the choke with a primer bulb added a pisser (since i removed the over temp sensor)

finally got the umi steering (for a wave blaster) installed. took a little rearranging/relocating of parts to get everything to line up. the cross brace and cable holder had to be spaced down to align with the groove in the steering stem (for the bracket). this also required slotting the holes...