Search results

change it over. when i had my SN i spent an entire winter building it as a back up... my first ride out i did a small over-rotated nose stab and snapped it in 1/2. the following week i put an AC aluminum pole on it.

mine rubs a little too. I loosen the clamp on the long exhaust tube then wiggled it a bit to help set it at an angle. It still rubs, but just barely.

installed the final piece, the chin pad, last night... gonna go ride later this week and try her out.

PM E.J. on here... i think it was like $35 shipped... great set up. and they come with a center guide to mount to the hood to keep any hood side to side play.

Holy crap! What happened man? I am using E.J.'s SS ratchet setup... it opens fast and easy if you do it right.... pull up on the ratched release, grab the end (tail) hanging out and give it a yank... it will release very quickly... you can see the tail i am refering to hanging down in front...

i did the sides like this: Fill in the bond line with foam and sand even with sides 1 layer of 8.9oz texalium - 3" wide strip to cover the bond line 1 layer of 8.9oz texalium - 8" wide strip to cover that 1 lay of 14oz biax cloth covering the entire side - nose to bulkhead didn't really...

couple more

My WDK chin pad will be in today... then I'm finished and ready to ride. Friggin stoked!!

i've seen that happen... check the two wires where they connect to the bottom most coil on the stator.

Looking good John!

LOL My other ski is a -4" AC pole with short turn plate and straight bars. This one is a -6" AC pole with a short turn plate and straight bars. I like it short like that, although longer rides makes my back tired.

Fired the new orange beast up last night... now i'm really friggin stoked. I love the smell of two stroke!!! just need to wire up the bilge pump, turf it, and install my new WDK pole pad when it arrives Monday. Here's a few... need to clean up the wiring and hoses a bit still too...

pump, motor, exhaust and electricals are all in now... just need to install the tank, wire up the bilge pump, finish the last couple cooling lines and turf that focker! My new WDK chin pad will be here next monday too. On a side note, i am not real happy with the way my -6" AC pole looks...

I can't wait to get it. I run a Blowsion Carbon chin pad on my other ski, and it's taken quite a beating, but for $250 it better. The WDK one is priced way better.

Mine will be here next Monday!!! Can't wait.

WHAT'S SUMMER?

a few more pics... just need to install the pump and motor

nice. No, my AC bushings are about 3mm short of being flush with the inside of the pole.

yeah? with that make much difference?

i hear ya... i like the feeling of being more fluid and one with the machine/water... rather than a feeling like i'm fighting it or working too hard with it.