Search results

I need to know the exact diameter or the bolt/rod that the handlepole pivots on. I need to know how wide the handlepole is where is attaches to the pivot bracket I need to know how far it is from the center of the handlepole pivot hole to the start of the hood. I included a picture with...

Its a modified mikuni, taper bored and the bombsight has bee removed for a differnt type of venturi. Does anyone know who did these mods and if they were any good? picture is attached. Thanks guys

What is the differnce other then the attached shoe on teh kawi 650 pumps compared to the 750 pumps? I see some people replace the 650 with a 750. When checking, they are both 140mm pumps. Whats the deal?

Has anyone put twin carbs on an X2? Did you need to modify the hull supports or anything else?

I took apart some 750 cases today. This is what i found. Will it be a problem or do these surfaces not need to be perfect? Actually most of them feel super smooth. Only the front section seems like it it rough and has been chewed/ground up a little. IF they cant be used like this is...

I have a Kawi 750 Small Pin that needs to be redone. I am going to put it in an X2 and i am looking for Low End. Hitting 50mph+ would be nice too. I plan on using 650 electronics and flywheel I want to use 93 octane pump gas How far would you bore it out? I was planning on 2mm over...