Search results

IF you have an old analog MSD TL system and now how to check resistance specs with a mulitmeter, and you are willing to help out, let me know. The plug in modules to set your timing curve are just different valued resistors. They take about 10 seconds to check. These modules are...

Is is possible to replace the gear ring on a flywheel? IF you can, how do you do it?

http://www.mcmaster.com/ Do a search for hood latch on mcmaster. It wont let me copy the whole link

Is it possible to use a 650 flywheel and stator with 750 cdi and electronics box? This is for kawasaki of course.

Which would you go with? MSD TL (analog version) Advent with an OEM flywheel, magnets removed and flywheel lightened (should be within a pound of an Aluminum TL wheel) Advent with a Jetinetics charging wheel

What size does everyone go up to when replacing the set screws. One of mine is toast and needs to be drilled. I was thinking of going metric M5 but if using 1/4-28 or 1/4-20 can be done without making it too hard to tune or degrade performance it would save me some dough in taps and drill...

Can you setup an advent igntion with an msd flywheel and pickup?

Do the magnum pumps just offer better hookup in rough water or do they add bottom, midrange or top end too?

What modifications do you need to do to the rest of your engine when dropping a stroker crank in? Say 5mm

Where do you guys buy your parts from? Im looking for reeds and stuffers but most places dont seem to carry what i need. Any good places to go?

Link to original info -->http://www.torquecentral.com/archive/index.php/t-21629 homebrew boosters.. Formula #1 - Toluene R+M/2.........114 Cost...........$2.50/gal Mixtures with 92 Octane Premium 10%...........94.2 Octane 20%...........96.4 Octane 30%...........98.6 Octane...

I know its been done, does anyone know how far up or down and forward or back the engine has to be moved to line up correctly?

What do you guys run or recomend? I have a kawi 750 that is ported, bored out +2mm, MSD TL, single 46mm carb, head 180psi, factory 750sx pipe. right now i have stock cages and stock reeds.

is there any downside to changing the side exhaust to a rear exhaust? Why dont more people do this mod?

For you guys who have ridden both. which did you like better and why?

Does anyone know if you can use a PJS total loss flywheel with an MSD system? PJS flywheel MSD Brain MSD Pickup MSD Coil

I have 2 kawasaki 750 engines, they have a letter stamped on the upper cylinder case. one has an A and the other has a C Does anyone know what the differences are and if one is preferred to teh other?

Can anyone tell me the correct cooling line routing for a 750 engine in an X2 with a coffmans pipe. The person i bought it from has it hoked up all wrong. problem is i dont know how to fix it and i dont want to screw it up.

Does anyone know how long the splines are on the 650 and 750 drive shafts? I think that is the only difference between the 2 and I am trying to figure out if i have a 650 or 750 shaft in my modded x2 i just bought. It has a 750 motor and 750 pump. Trying to figure out which impeller i...

I have been trying to find out what the stock compression is for this ski. Everything i have read conflicts so far. Some people are saying 150psi stock some 179psi stock. I think the problem is there are 3 models getting confused, the sxi the sxi pro and all other 750 models (non standups)...