Search results

You will have to remove the flywheel cover

Before you do all that get an inspection mirror and a flashlight and you can inspect the teeth on the flywheel without removing it , I know quite a but about this because the 91 Seadoos came with improper spacing between the starter and the flywheel, we replaced a ton of ring gears on those till...

Most likely the teeth on the flywheel are toast , the bendix engages the same set of teeth on the ring gear every time , about ten or so teeth on each side of the flywheel , eventually these get worn down and when the bendix gets to those spots it disengages , I have replaced ring gears before...

Shouldn'ta Bought Trash

Yep I glued a set back in my trailer winch been working for years now with no issues

It's ok BK , on that four stroker the oil and gas will mix itself

What I usually do is pour the oil in the ratio rite , then fill the rest of the ratio rite with gas then pour it in the fuel jug and put it in the ski I feel at that point its mixed enough especially if you are going somewhere to ride , if you are refilling at the ride spot maybe shake it up a...

Mr Ho uses only leftover cooking oil from the Chinese restaurant .

Working on my stuff this week, finally ! I took the STS 750 out yesterday afternoon and the trim isn't working , very common on Kawi trim systems , I decided to tear into and see whats up , Checked the fuse all good, checked power going to trim motor all good , that just leaves the trim motor...

No there were some other patterns , click on the link in the first post then click on the search button up top and it will bring all of them up.

If it was ignition related turning off the fuel wouldn't make it any better , ignition and carb symptoms sometimes overlap but on this one I would follow Fastfairlanes lead

Pretty good brushed texture to it but those diamonds are really big like 2 inches by 6.5 inches big , I am not sure I would want to try to turf a Superjet with it . My worry is that it will come apart where the grey is bonded to the blue but that's my worry on Hydroturf aslo , I would think...

Yep gold paint and all, I like the stripes just don't like the colors. https://www.x-h2o.com/threads/the-nineteen-nineties-just-called.209653/#post-2147803

It's finally here , I had to raise some hell to get it here and they owe me $5.00 for it arriving late, but they did give me 20% off of my next order which I already burned up , it's a little different but I kinda dig it, I am going to ignore that it's PSA and just Dap weldwood it, I am sure...

Usually if the steering moves one way and not the other the cable is broken inside , the cable will still push but it won't pull.

Biax shrimp Ramen , it's waterproof and submersible. You can always use wire mesh like this guy lol.

Those rubber trim seals for the pumps get compressed over the years and they don't seal up well anymore , especially if the pump has been off a few times , I have had to back them up with Right stuff sealant before to get them to seal up properly . Impeller damage should be obvious if it's...

The ad is just a sample , I did see plenty of 650 VXR shafts on there as well and some whole assemblies for like $50 , even if the housing was toast you could probably still press out the shaft and use it, just a suggestion.

My book says VXR , Waveblaster and Superjet all carry the same midshaft , at any rate there are a bunch of them on Ebay...

Mister Ho uses Ramen noodles for a core !