Search results

I had one. Wish I still did it was a Good motor had lots of power pulled a tall prop well I had no issues with it. Sold it to a member on here for to cheap but oh well. It was a 5mil stoker lightweight crank 1 of a kind 85bore 828cc I think. Really ran good too cases were slightly trenched and...

I believe mine would still be running if it wasn’t for the spark plug end breaking off and it just kept trying to jump the gap and I kept the motor running. Hard telling lol. It had worked great for about 2 years until then.

No I don’t have a cable to test the zeel but eventually I will. I discovered a broken spark plug at the boot after it quit running completely it ran on one cylinder for awhile trying to get back to my truck,it had no spark. I tore it apart checked everything out replaced the coil and still no ⚡️...

I found what I was looking looking for. Thanks Fellas

Does it plug into the 760 harness. I’m running it as TL and how much? PM sent.

Looking for another 760 zeeltronic brain only mine seems to have lost spark.

I ran out and installed a new battery on the ski and cranked it over and I still have zero spark. Thanks that was a good tip wish it would have worked. By the way how much would a new brain be for a 760 zeel.?

Oops wasn’t finished posting yet . My Zeeltronic quit on me yesterday first ride in a while. Started sputtering losing power so I limped back to shore had a backfire then it died. No start. Went home pulled the motor and tore it apart everything looked good except a broken spark plug terminal...

Anyone have any ideas

I believe it’s just the way the badass was designed. Everything is as low and compact as possible including the engine which is like a 1/4” from the botton of the hull giving it a very low center of gravity which makes the handling so special IMO. When you chop the throttle on mine after a high...

My Badass has a custom .75” shorter pre08 driveshaft for some reason . I fitted a 148 pump shoe/sb pump in mine and the intake grate hangs way low . The effort you went to make the 155 pump fit is extensive I’m sure I hope it works well for your ski.

I usually just plug the charger I bought for the battery in after each ride. It came with a little harness that attached to the battery and has an inline fuse. (Battery Tender) So it’s just a simple plug ,the red light comes on when it’s charging turns green when fully charged and shuts off...

I have used the battery tender lithium battery by deltran for about 6years now I think it has 500ca. The heat here in Arizona has just ruined the 2nd one and they cost me 200$. So this Noco battery is less than half that so I’m confident that lithium battery technology has advanced so much the...

I bought a NLP 9 and it cranks up my 800cc TL every time No problems. It’s a small battery too but if you could fit a bigger one go for it but I don’t think it’s necessary. They have plenty of ah as long as your ski starts properly as the starter uses all the amps. The motor will run for a long...

https://www.x-h2o.com/threads/new-zeeltronics-y62t-cdi.204088/unread

Not sure if 701 industries from down under is still around but there cheap little plastic easy start has come in very handy for me making a quick getaway before getting hit by the next wave. Really nice when your flushing also you don’t have find a lanyard.

I just have to give this ski a bump. Wish I was looking for a new buoy ski as this one is on another level compared to the new Superjet . Surprised it’s still here! Looks like new too.

Oh ok so the rods must attach farther out the crank pin then? so the 5mm gets you the same increase in displacement? Thanks for the info

Can I ask a silly question How come this Stroker crank doesn’t have a spacer plate under the cylinder? I had an HPE 5mil Ada crank 828cc. ported 61x and I had to install various thickness spacer plates and gaskets to get the squish just right and that motor ran like a raped ape!! Wish I still...