Search results

Pressurized system, does not matter how far they drape other than looking sloppy and possibly rubbing on other items in the bilge.

Thanks Shawn, it sounds like I am going to help him out in a couple/few weeks.

I thought for sure you were going to sink it in the first minute and a half.

With a stock ignition curve I would think that 31cc domes are going to be very risky on pump gas.

Still running a B pipe? What ignition?

Sent you a PM.

I would send your entire topend to a competent engine builder and get a professional opinion, a lot of what you are saying doesn't make sense. If you want actual help on here, you will need to take pictures (good) and measurements (accurate). Starting a new thread with those two items will...

FWIW I have a set of 46SBNs that were in a Riva race Blaster (stroker?), just pulled the plates and found: 2.5NS 115 gram spring 120 Pilot 110 Main After a bit of digging I found some posts from Supertune and Waxhead that mentioned a baseline very similar, I will be starting here on my 718...

If the piston didn't fit in the top of the cylinder....how did you possibly get a chance to compression test it? You are not looking to see if the rings are hung up on the walls, you want to see if they are sticking in the grooves on the piston and not allowing them to seat against the...

If you get no help/response here from somebody with actual experience on this setup, I would take a look at the carb tuning database in the FAQ section and find a setup with dual 46s on a 701/760. The engines are not the same BUT if you can assume the carbs are the same, the displacement is...

Jetski Escher (JS Escher/SJ Escher?)

How many pieces did it take to build the topdeck and how do they attach together?

You can likely find a decent used carb for $75-$100 (or sometimes less). @LIVE2RIDE Powersports usually has carbs for cheap, shoot him a message.

Lake City, MN on Lake Pepin/Minnesota River, Aug. 21-23. It is basically the Dells freeride's older brother. https://www.facebook.com/events/660109567426579/

It depends on what domes are in the head but I would expect to see no less than 150. Try with a different gauge, if that still shows low pull the topend and make sure you installed the piston rings, installed them correctly, they are not stuck in the piston grooves and that your cylinder bore is...

Will you be bringing it to the TCJP Sortie?

What you are trying to get is the steer cable as close to the centerline of your trim nozzle as possible (the two horizontal screws it pivots on) this will reduce the deflection on the cable and the turning effect it has on the nozzle when the trim is used. Right now with it bottom mounted AND...

Tab broke, no good way to fix it, buy a replacement carb or set your idle with the cable adjustment.

I think he is saying the protrusion on the carb that the idle screw is threaded into broke off.

Inline resonator or just increased tubing size on that exhaust?