Search results

This took some digging but immediately came to mind.

1:1 is a bit of a stretch...it closely resembles a PFP, if you are drunk.

Check AirBnB

I think so, for now :D

Put some parts in my storage bin too :)

Had a killer surf session today until the wake shaper forced a few gallons of water into the gas tank breather and shut her down. Drained her out and fired back up, ready to get out for another session. There are six of these.

You spelled Bryan and shop wrong.

Swap your handpole and steering cable for a pre 2008 superjet setup. The 2008+ steering is poor.

Hopefully somebody here can help me out. I am trying to figure out what driveshaft I need to put a stock 155 pump in my Maxx hull. I have received a measurement from a Maxx setback pump from the face of the wear ring to the end of the splines (see picture below, not of the same pump but what was...

Is there still openings at hotels? Any places recommended?

First time going, just making it a quick weekend trip. @KMN and I will be down there Friday evening till Monday evening (10/6-10/9).

Is there a trick to getting the retainer spring loops on that hold the bellows on new style low pro powervalves?

That's what I've been using, the flex shaft style with footpedal and hanging motor.

I got one, pissed fuel out of the seam on the handle first fill up.

add straps

My junk.

Stumbled upon this, the paint job is pretty amazing.

Xscream uses the 66E cases and crank for their 1200 and 1400 for the same reasons.

No, you want the combustion of one cylinder to drive the other back up.

There was a picture that showed some sort of boss on the side of the cases, possibly for a balance shaft or waterpump (for a closed loop and/or non watercraft application).