Search results

Never ran it but I did use it to make a mold once. Should fit superjet as well and can easily be trimmed however you like. $100 shipped or delivered to Daytona Freeride

Attaches to ski and bag full of 100ft rope floats to help keep sunk ski located. Never used. $65 shipped

$600 shipped https://shop.jetworksperformance.com/jetworks-850-super-bore-ss-top-end-kit/dp/217 Engine hydrolocked and broke rod with 10 hours after rebuild. Slight cylinder sleeve damage that I have been told by Paul Lehr can be cut into a small window with no affect to engine performance at...

Painted red after beadblasted before sending them to be blackjacked in 2017. Guy who had this done dropped them after getting them back and broke idle screw arm so he never used them but i bought them and repaired it with aluminum stock and jb weld and a bolt. I've ran them for 2 years with no...

Hogging out bolt holes on some couch mounts for engine alignment in a superfreak. I held the mount in my left hand and drilled with the right. The bit grabbed the mount and twisted my hand so that the thumb was caught between drill bit and the mount. I let go of power immediately but the damage...

Whatcha got?

My fingertips are raw from compressing rings and it's still not on and I gave up for the day. Engine in hull:1 Me: 0

Do You think this is from age, saltwater exposure, or incorrect installation? Steering hits bump stock in both directions so I'm suspecting corrosion.

In good shape. If new will pay new price.

So a little saltwater got in my flywheel compartment. Culprit was slightly warped sealing surface with cover from shipping damage causing gasket not to seal. Going to oring cover and hoping for the best. So after tearing through 3 different ignitions I have come to discover that it was either...

65v is the one with a little "up" trim. The stock siphon on this one is filled with jb weld. Both in good condition. $75 each shipped.

Has some blemishes as shown. New hardware. $110 shipped.

Brand new from Thrust. I ended up using it as a plug for a mold to make my own with extended hull sections and it has been sitting ever since. Fiberglass. I think it will work for super jets too. $125 shipped.

Brand new with brand new bearings and seals installed by Rhaas. $150 shipped. If you send me your midshaft I will press it in for you for free.

http://www.x-h2o.com/index.php?threads/updated-the-retriever.126544/ No longer made. Bought new and sat in a box ever since. $70 shipped.

3 inch tau ceti tornados in perfect condition with blowsion outerwears: $110 shipped SOLD 1 inch tau ceti tornados in perfect condition: $90 shipped Prok with 2 outerwears that is best I ever had. Its mate was replaced 3 times from disintegrating while this one stayed perfect: $40 shipped...

Rrp = $175 shipped Brapworx = $125 shipped

I just took a dremel to the bottom for more traction. I'll post up how they hold up and if the traction mod worked or not. 1st lesson: the melted rubber will not come off your shirt.

I'm about to run a wet pfp with a rrp waterbox in the surf and I'm worried about water getting to engine if ski floats without engine running. Does anyone make any sort of exhaust valve or scupper? Any suggestions? Am I just being paranoid?

I recently rewired a total loss and after using it and it functioning perfectly I discovered that it was throwing current into my carbon hull where the ebox attaches to the hull and melted my epoxy out of the carbon around one bolt hole. I haven't torn into it yet but I'd like to trouble shoot...