Search results

Anyone know who has them in stock? Or when the next batch is due?

What's the best top loader for the XFS? Cheers, Jim

Does anyone know where to get the carbon tubes I've seen on some RRP poles? Don't think Rick Roy does them? Jim

Is the type 9 pipe similar/same as a power factor pipe? Would swapping out my B pipe on my 6mm DASA stroker for a type 9 see any benefits - I'm running TL and Full Specs as well. Reason for asking is I can get a type 9 at a killer price and thought it might be a cheap Perf upgrade?

Anyone know what a 2000 RN SJ weighs? Considering a move to the XFT and wondering how much lighter it will be? Cheers, Jim

Are they unrideable in the surf? Do they need a longer ride plate? I'm looking for 90% flat water boat, just don't want something I can't use in mild surf (up to 6ft) Jim

What does an stock SJ hull and hood weigh bare (excl engine/pump/pole etc) Would be interested in new and waterlogged weights? Thanks, Jim

My pole bolt has seized into the bracket and I can't shift it - is the RRP pole bracket threaded? Anyone else had this or know of a solution? Thanks Jim

:bigok: :bigok:

Well, finally nailed it - started with inverts and then over rotating them tucking more and going higher. Right leg has been bruised to :-):-):-):-) learning the last 1/4 rotation! Will get some footage from the shore this weekend - the onboard perspective is cool and hopefully gives...

Do scat trak make the magnum pump? Do they have a web site? Cheers jim

http://www.vimeo.com/6890730 Welshwizard from the UK put it together this week - enjoy! Cheers, Jim

http://www.vimeo.com/6890730 Welshwizard from the UK put it together this week - enjoy! Cheers, Jim

When combined with lamey stroker? Currently have a b pipe, just wondered if it was any better? Aren't the new EME pipes dry? Cheers jim

this looks real nice! Www.carbonsuperjet.co.uk Cheers Jim

Looking for some help to check I have the start stop switch wired up correctly? - This is a new JSS built board so the rest of the wiring should be A1, the only bit I needed to do is the Start/Stop and I'm stuck! I have cabled the Start/Stop as follows: • Red & Black from Start/Stop...

Some shots from today.. Stabs.. Jump Fruit loop: Aussie barefoot: Rodeo: Cheers, Jim www.pierats.co.uk

Anyone know if its straight forward to remove an aftermarket paint job with say Nitromours back to the original Gell Coat and polish to a good finish? Or is there a better way?:thinking:

Looking for some help on where to set the following water injection screws on my B Pipe: Top of header pipe Middle of header pipe Bottom of header pipe Motor is a 62T 6mm DASA stroker with dual cooling (lots of water pressure) Motor loads up like a mother when tail standing and when...

Started doing Inverts and attempting rolls - when I go upside down I seem to stand up and stop the rotation and it turns into a big inverted stab (the water slap on the chops is getting a bit long in the tooth now!) Am I high enough lookin at these? - where am I going wrong? I run...