Search results

It runs

Do you have a pic of one done?

Sounds like a bad ground or a bad lead

I wanna go 60 + you could check compression on the cylinders if your worried . but if it cracks off on the trailer Id take it out as is. Also you might consider a hool seal in the near future

yeah Brian I know where you talking about . I think I am going to go ahead and vent the hood for exrta air flow ....

A little . epoxied and glassed in inserts for the fuel cell and battery box. . the pic just shows them epoxied in place finally sealed the new filler and managed to bolt it to the new tank and ran the fuel lines . I am running the maxxx pole with the dual breather tubes, I am still...

Power factor makes one I think rrp. And rad dudes makes the vault

That smaller mid bearing is the only one that will fit on your hull. As long as your bearings are good you will be fine. If not contact jet maniac to have your bearing rebuilt

I think they are cool and nicely made. But what are they used for ? Serious? Re you using these for overseas transport or trailer use ?

What he said

wow that looks like fun !

4 gallons fit but its FULL Thanks I appreciate your help and input thank stole the idea from the Canadians

Topped off my new fuel cell with a Wamiltons pick up / fuel fill

Pissers

Search c.a.t.s Cheap ass trim systems

Sent you a pm.

Agreed 12 Oz biax is strong and easy to work with. If you want you can tint the resin

Looks to me on the intake manifold it says 61x. Which is a 701. Plus that setup has a Coffman pipe. Which is better than stock

I just fought this same problem. I found the lower right through tube was the only one the cable would fit through. But the nozzle maxed out hit the tray and I didn't want to trim the tray. So I used it for a down trim instead and drilled a new through hole It was not my boat and if it...

Which gasket are you talki g about I'd use the ones from factory pipe