Search results

The first one looks cleaner. I'd check that one out first if I was you.

Whatchoo mean? We're sitting on a beautiful green 5 acres here in NorCal :) 3 minute drive to the launch ramp too ! Clean ski and build op!! I've always wanted a freak ;)

Got everything installed including a h2o water box, atp flame with a custom plexiglass mount, new exhaust tube ran through hull with a support. Still need to run fuel lines and waiting for hood pins and ride plate from wdk. I wish I had pictures of the install but I don't build things like a...

Definitely sounds lean. I personally never had luck with those pre filters either try without those .

Why don't you yes loosen the bolts and rotate the center section there are no wires on it. Just a metal cylinder with magnets inside

Hey I have a CDI off a running 96 750sxi for sale looking for $60 shipped

There's a screw in the front as you can see in the pic below and there are two more on the insides near the pole bolt (same place as stock superjet)

If I had shipped it I would've. Think there was a shipping costs thing going on

No he didn't and they were kinda halfway covered and laying on top of each other. the usps box was all effed up though.

Yess!! Someone makes metal ones I think? Idk

Are you trying to save the black part? Smack that beyatch with a hammer. Or if you want to be a little more civilized use a dremel with a cutoff disk

That would work perfect. Put some D rings on the back sides of the trailer so you can strap the rear of the skis down

That's the exact trailer I started with I can send you more pictures of my trailer if you want

This is shortened from its original form 20 somethin foot boat trailer and right now it holds 3 skis and could hold 4 but i wanted room in between the skis for a platform to be installed for gas cans and gear. It's 80 inches also.

If you wanna fund your superjet build I just have to ask. How much for the octane

We still need quite a few parts. And a good powder coater in 209 area

The alien motion lithiums are great. I just ran one through pismo for 4 days and it's still going strong. Charging it from a charger I had for rc cars.

Thanks for the reply I was thinking I could get away with 1211 on the seal area. The boxes they came in were pretty damaged upon first inspection of the outside of the box. I was suspicious of what damage had occurred on the inside.

I just bought some cases here on the x and they were very clean and I trust the seller. The damage are dents and dings on the sealing surface of the front crank seal and on cylinder deck surface. Just wanting to know what actions to take and if they would be safe to run.