Search results

I'am installing my new msd in my ebox on my superjet, and i was wondering,how the e-box is getting his ground ? my negative cable from the battery goes to the engine, for the starter, but no other cable go to the ebox to give ground for cdi, rectifier etc...Last year my stock cdi blow up and i...

OK yesterday I ran my jet to test the 61x cdi . For the rev limiter I think it is pretty much the same as the 62t cdi, i'm not running in the cut off, but, I am sure that the timming curve is not the same cuz I notice that I have a lot less power in the low end range. I do not have anymore my...

And what about just solder a jumper to cancel the rev limiter?

I heard that the oldder cdi 61x have a lower rev limiter ..??

I use oem bearings cuz the old oem ones have done pretty much 12 years !

Does the 95 and less 61x cdi are the same as the 96+ 62T Cdi ?? Will it change my performance if I run a 61X cdi on my 96 superjet?

Cuz i'm talking about the fx1 of my friend, that cavitate a lot. I will check the drive shaft bearings and seals if they leak.. and the gap between the impeller and de wear ring, what else can make the pump cavitate ? I'm talking about; always in the cut off even on a mirror lake, like if the...

Okay thanks I will look for a 19-25.. and does skat trak made impeller too for fx1?

OK thanks! I think that the small pump on the fx1 is choking the low end punch ... I gonna continue reading ! Thanks again

solas 17/23 yc-sc-1 Is this a good impeller and pitch for bottom end and flat water tricks? Thanks all

Hey nuklear6 ! You have a kawa pump on your fx1 ? Is it easy to fit? is this a good move for freestyle? Cuz we are searching for a impeller for the fx1, what pitch do you recommand with a stock engine with the pipe. Does it worth the 300$ for a 140mm pump? Or we are better to invest in a bigger...

any one can help me here

One of my friend just buy a FX1, and we was wondering if all superjet's pipes fit in the fx1? I know that the coffman sizzler fit but hard to find. Does a protec mach 1 fit ? What about the b-pipe? Any mod needed ? I will take any input about ''how to tune a fx1'' for freestyle. Thanks guys.

Cool thanks all !! :P

ok thanks! But stock 1.5 n/s is ok ?

Can someone explain to me the way to close and open screws on my b pipe... I want to close them cuz my pipe is running to cold . So who can tell me... I close or open, clock wise or counter? Help! Thanks!!

I have a 96 superjet with following upgrades .. let me know the best way to jet my carbs ..( dual 38 ) -82 mm oversize -matching exhaust and base port, just make it mild, no enlarging. -factory b pipe -vortex ocean pro flame arrestor - stock light milled head ( 160 psi ) Thanks all!!

Anyone!?

I got 96 superjet with b pipe, milled head 160 psi, fresh wiseco 82mm, dual 38 carb rejeted with pipe, stock intake + reed... what is the best mix I should run ... now I run 45 / 1 with standard repsol marine. with 91 octane fuel. Thanks

Do a 1993 waveblaster with 61x engine have the same starter bendix then a 62t 701 or 760 engine do? Thanks!