Search results

I had that problem too. Mine was clogged.

Do you fill the whole tube or stuff in a plug like aluminum foil and then fill the last 1/2" or so ? When I was jetting I found that the pilot had greatest effect on mid range and [this is the wierd part], the low speed screw setting. The pop-off had a greater effect on acceleration. Which is...

I just installed a Jet Works flow control valve on an SXR with Factory wetpipe. I had a nasty bog doing tailstands . This clear up the bogging, completely. I had a bit of a problem installing it but got around it. First i tried just splicing it into the hose that runs from the bottom of the...

OK so I finally recieved a selection of jets , needles & springs. I spend the last two days tuning and slamming my head on the work bench. I was surprized with what I ended up with. #2 Needle seat 95 gram spring Low screw 1_1/2 out 75 Pilot 152.5 main High screw 1/2 out The 75 pilot jet...

every 1/2 second is not fast enough? The Pet 2100 DX is over $200

No I don't have a tach yet but am planning on getting a Tiny Tach. What is the stock seat and spring combo?

I have stock carbs jetted to Factory Wet Pipe recommended jets. See below for all mods. Pop Off Spring = stock Pop Off Valve = stock Pilot Jet = 80 Main Jet = 152.5 High Speed Screw = 1/2 out Mid and top end are crisp, plug is light brown/tan when run wfo. When riding around at low to mid...

Thanks I'm glad to hear this. I am tuning for bottom end. Now to fine tune the carbs but that's another post.

So I installed a FP wetpipe late last season according to the instructions and went out for a ride. Changed fitting on pump and rejetted carbs Original Plumbing Water In Tube => Exhaust Manifold Rear Cyl. Out => Water Outboard & T-Fitting => Stinger Front Cyl. Out => Headpipe Bottom Headpipe...