Search results

Awesome. Thanks guys. Got what I need

Installing MSD ignition in 2017 SJ. Quick question. It looks like stock setup has battery cable coming out of starboard. Wiring diagram from MSD has battery coming out of port so I had to swap the leads. which is correct? Man I hope its the latter because its all back together First pic...

Thank you. Do you glue in the tube with marine sealant? Also how do you keep water from coming in engine bay? Just run bilge all the time?

I was planning on running dual cooling at the motor is being ported so the stock siphon will be used. With the stainless tube, that just acts as a thru hull? Did you guys just use a hole saw and fill with 3m 5200 or something of that nature? If anyone has pics of their setup and thru hull...

Anyone have any info on installation. The setup on the nozzle seems straight forward. But how and where do I run the cable? Thanks Also any advice on making sure it is set up correctly? Like how much angle and slack I should have?

2017 SJ. Tastefully modded. Super clean and tuned to perfection. Mods listed below. 7500 B pipe ADA girdled head V force reeds Hot products F/As Primer kit Worx 228 intake Bilge pump with dash switch Finger throttle Billet pissers Billet throttle cable wheel ODI grips Aftermarket exhaust...

Here it is

I can take a pic later for you. contact jetmaniac on the site. He has a kit that is way cheaper.

I like this style switch mounted near your primer https://www.blowsion.com/bilge-switch-3-position not a fan of the handlebar switch. too crowded to run it and too messy

Is it just the hull and pole?

Where is it located?

Yes please. 48657

Where are you located?

how hard are these to install on a superjet?

Tilt up, run motor for 5-10 secs. Give it gas. Repeat x 3 Fog cylinders. Pull battery. Done

You can get one for way cheaper than that new. Search around for other dealers or a leftover. Or even drive a few miles to get one.

Just buy a new one. You won't save much buying used. 6k used. 7-7500 new

Stock? Mods? Condition? Salt water use?

Assuming it wasn't removed with bilge installation.... The water collection tray is at the rear of the engine compartment below the shaft. Might need to remove the shaft cover to see it. The hose connects there and should exit the port side rear of engine compartment. Some people remove the...

Is your stock siphon bilge clogged? Or did it come loose?