Zeeltronic 787rotax

[Greglees]

Has anyone put a zeeltronic on a 787 as I was needing the ignition curve mapping
It’s for a zeeltronic o dis a02t
And has the spx 787 got a different map to a gsx and xp 800

 

[Sanoman]

Possibly @Jr. may be able to help or may know someone that does.

 

[beerdart]

Has anyone put a zeeltronic on a 787 as I was needing the ignition curve mapping
It’s for a zeeltronic o dis a02t
And has the spx 787 got a different map to a gsx and xp 800

Yes many both A02 and 24 the 24 has 2 channel water injection built in.

 

[Greglees]

Do any of you guys have the correct ignition base timing and ignition curve figures

 

[kevbo]

For what compression, fuel, RPM, and carb setting? I cant tell you but I know they're easy to burn up.

 

[Greglees]

For what compression, fuel, RPM, and carb setting? I cant tell you but I know they're easy to burn up.

Standard engine except for mikuni buckshot carbs so basically the std mpem settings

 

[WFO Speedracer]

JC Superjet posted this curve over on PWCT.

https://www.pwctoday.com/forum/technical-discussion/sea-doo/161391-

 

[beerdart]

Standard engine except for mikuni buckshot carbs so basically the std mpem settings

 

[Greglees]

So which wires on the zeeltronic a02t go to the pickup wires
I have the violet and green wires which say to go to pickup
On the motor plug end I have a black and a yellow/black coming from magneto

 

[WFO Speedracer]

I would say red/white to yellow/black and green to black

 

[Greglees]

So I’ve programmed the zeeltronic but won’t stay running under 3000 and a poop to start
Can somebody tell me what the trigger type should be for a 787 is it
Single lobe
Twin lobe
Or one short and 2 long lobes
Also should the stop switch mode be on
Low level stop
High level stop
Or latching stop
This is what I have programmed now

 

[WFO Speedracer]

I would say single lobe but then I have no actual experience working with a Zeel.

 

[Jcary85]

So I’ve programmed the zeeltronic but won’t stay running under 3000 and a poop to start
Can somebody tell me what the trigger type should be for a 787 is it
Single lobe
Twin lobe
Or one short and 2 long lobes
Also should the stop switch mode be on
Low level stop
High level stop
Or latching stop
This is what I have programmed now

Looking at pictures of the flywheel I see two lobes. It should be twin lobe. Stop configuration looks fine. There’s a very good manual for these that covers a lot of this information. I’d strongly suggest giving it a read.