Wich one of these shaft holder work on superjet?

[nickt916]

im a little confused... wich one will fit 99 superjet shaft so i can spin the impeller off?

http://www.parkeryamaha.com/index.a...tSearch=Driveshaft+Holder&btnSearch=GO&Page=1

 

[#ZERO]

You're going to need the YB driveshaft tool and you will need the tool that goes in the impeller also if one didn’t come with your prop.

 

[nickt916]

thanks ordered YB, ill see what comes with the skat trak, and whats the other piece? this thing? http://www.parkeryamaha.com/index.asp?PageAction=VIEWPROD&ProdID=17365

 

[Brenden]

thats what goes in the impeller to put the new one on and tighten it

 

[nickt916]

thats what goes in the impeller to put the new one on and tighten it

so i need both tools then, the shaft holder and the impeller tool? but why would i need the impeller tool i can just hold the shaft with the shaft hold and tighten the impeller by hand the best i can and that should be good enough since the impeller tightens itself everytime you ride, there is no way it would get loose unless you had reverse on your jet...

 

[michael950]

You have to hold the shaft to remove the impeller, thus the shaft tool.

You have to have the impeller tool to remove the impeller. Only a stock impeller does not require an impeller tool. This is a good thing.
Different impellers require different impeller tools.