wayne
wannaroll
- Location
- Mesquite, Texas
are you suppose to foam before installing the foot tray? or can you leave expansion holes so you don't have to shave all the foam flat?
when to foam
- Thread starter wayne
- Start date
oxnard111
Creative RE Purchasing
- Location
- so Cali, Ventura/Oxnard area
leave "expansion holes" behind the foot holds. install the holds, then fill with foam.
wayne
wannaroll
- Location
- Mesquite, Texas
so reglass every thing back in and just leave the expansion holes?
then tilt it nose down and fill from the holes at the back of the footholds? then just shave the expansion holes and glass?
first time doing this and don't want to screw it up.
thanks for every ones input
then tilt it nose down and fill from the holes at the back of the footholds? then just shave the expansion holes and glass?
first time doing this and don't want to screw it up.
thanks for every ones input
Superjet3
Waterlogged
- Location
- Jersey Shore
foam with the cutouts and then trim the foam and seal it up.
Mouthfulloflake
ISJWTA member #2
- Location
- NW Arkansas
ive seen folks lately pour foam in with the tray NOT glassed in, and then trim it all, and THEN glass it in and foam again.
that seems wasteful to me.
glass it in, and pour the foam in steps, NOT one giant pour, and you can fill it completely and not waste so much or make a giant mess.
that seems wasteful to me.
glass it in, and pour the foam in steps, NOT one giant pour, and you can fill it completely and not waste so much or make a giant mess.
Swooperjet
Bring the brap!!
- Location
- Dallas, TX
Thanks to you and the other guys. That's what we were thinking about wasting foam and spending time trimming the foam down.
Just have a short period of time to get these done, so didn't wanna f-up and have to redo this.
Appreciate it!!:bigok: